How do I turn off the power on my pioneer N3

Hi,

I think there are problem with the screen flat cables might be foulty swap with another just to know if they are good .


good luck

blown fuse??? have you done any hack mods from avic 411

ready. ground the e brake. green wire. also because you have a pioneer(i do to) you will need to have a switch where the driver can reach cause every time you turn off your car (acc) then start again this switch needs to be ungrounded then re grounded let e know how it goes.
Kieran

exe has performed an illegal operation will shut down. program:mobilenavigator.exe exception 0xc0000005 adress:001394d0 can you help

the unit wound need to be sent out for repair. you can contact pioneer customer support at 1-800-746-6337

You need to reset the radio and put the CD back after the reset

We can fix this along with all over AVIC N1 N2 N3 problems. Check out or affordable repair service at www.turbotunes.com. We're ebay powersellers as well.

-Steve

yellow wire on back of pioneer unit is probably on wrong wire try switching it with the red wire ........yellow is constant power (saves memory time and last part of song or movie so when you get in the car again it will start from where it left off) if this doesn't work ground it to the car itself (black wire to frame not wire in-dash) try the wire switch first ........hope i was able to help

Sounds like you are having a problem with the ribbon cable from the screen to the board .you can find the cable at many places even in Ebay .Usually the price is around $60.00.

could be tuner, aerial. would send it off.