How to reset the clock on a oregano freestanding oven

Nice Australian cooker but an unknown make to us here in North America.

Clocks always flash when you cut the power to inform you that the clock is incorrect. Perhaps you had a power cut in the night. If you have tried to set the time and can't, you may have a sticky button.

https://www.manualslib.com/manual/1108521/Technika-Tu950tme8.html?page=16#manual

..

good to here that....

Good Afternoon Jayme,

I see that your Frigidaire freestanding electric range is having heating troubles.

I suggest giving your double oven a hard reset by cutting the power at the circuit breaker for at least 2-3 minutes.

After restoring power you will need to reset the clock. You will do this by entering in the time and pressing start.

Turn the oven on to heat up, and if it does not, I suggest either contacting the manufacturer or contacting your local authorized technician to diagnose your appliance. Hope this helps.

-Best Regards-
WP

Hello steve o - Typically error code F11 indicates a shorted keypad. Try resetting the range by unplugging it or flipping the household circuit breaker off. This usually will clear most false error codes. Wait approximately ten minutes and if the error code does not clear contact a professional to move forward accurately. Most likely the EOC on the range will need replacing.

kiss. first check the auto clock is set corectly
reset it my one asks you to hold 3 buttons down at the same time then it resets and you can set the time again..
if you stuff it up just start over. if that dose not work call a servise man nfor advise

The "F13" error code means "Bad EEPROM identification/Checksum error".

If reseting the power did not help then according to Frigidaire suggested corrective action the electronic oven control (aka EOC) has to be replaced.

- The part number for the EOC is AP3874704

Without a model number, my guess would be a stuck relay in the electronic clock/timer. Replace the Electronic clock/timer.

ah, you lucky guy. You can try a hard reset by unplugging the range for a good 1/2 hour, then plug back in. Unfortunutely this probably won't work, as these clock/timers are notorious for only lasting a few years. You have to blow $150+ and replace the clock/timer. Note: A hair dryer will help you get the face off the old one to put onto the new one.

Most F1 codes for frigidaire state bad EOC (clock) but the temp sensor is the least expensive place too start.

Please post the model number for he stove in question. Its harder to advise without it.

regards