Program button is stuck and shaking causes settings to change

To change the default program on your Hitachi SF-80P washing machine, follow these steps:

1. Press the "Power" button to turn on the washing machine.
2. Press the "Program" button until the desired wash program is displayed on the control panel.
3. Press the "Start/Pause" button to begin the wash cycle.
4. If you want to change the default program, press and hold the "Program" button until the control panel displays the default program screen.
5. Use the "Program" button to select the desired default program.
6. Press the "Start/Pause" button to set the default program.

Note: The default program is the wash cycle that the washing machine will automatically start when it is turned on. You can change the default program at any time by following these steps.

Sorry, dumb question, but I need to ask. The volume control on the left side is also the on/off switch, have you accidentally turned that off?

Press start stop button for 3 seconds, then you can select another cycle.:)

Hello,

Welcome to FixYa.

By stating "the dryer does work" indicates it is likely an issue with programming.

What are the chances you have the menu lock-out option turned "on"...also referred to as "child lock".

You may quickly rule this out or confirm it is the problem indeed, by trying this.

CHILD-SAFE START

1. Turn the machine off then on.
2. Press ENTER five times, then press P3 five
times. (This must be done within 15 seconds.)
3. “Delayed start” displays with “0” flashing in the
lower right corner. Press the Right Arrow button
to toggle the display to “3.”


**NOTE: Child-Safe Menu Button**
Please note that when you set the child-safe Start
button, the Menu button is automatically
programmed to delay for three seconds before it
becomes active. This prevents a child from
accidentally changing the program settings.
When you want to change a program, press the Menu
button for three seconds to activate the menus. The
Menu button will work normally (without the
three-second delay) until you have completed your
changes. If it is not pressed for two minutes, it will
automatically revert back to the child-safe mode.

Let me know if this indeed solves the problem but either way please keep me posted.

Thank you for choosing FixYa and good luck.

Regards,

Macmarkus :)

Your machine will only injser a # if the telephone line settings is set for tone dail.Press dataregistration,press set and scroll to usersettings scroll to tel line type and set it to tone.

The problem is a defective micro switch underneath the City button. Contact Escort about setting up a RMA to get your X50 fixed.

Mine is 5. Press the TV button and let it go. When it quits glowing press the power button and hold it down. Then press a number (1-86) on the keypad while holding the power button down. If the TV turns off, you are done. Press the power button again and the tv should come on. If it does not work. Release the power button for a second and then repeat with a different number until the tv turns off.

If you hold down the mute button (on front) and the two buttons on top...when you power up, it will reset.

I take it that pressing the 8500's City button won't switch sensitivity modes? If so, and if performing a RESET doesn't resolve this problem, then either the firmware is corrupted or (most likely) the micro-switch for the City button has gone bad and needs to either be replaced or possibly resoldered so that its two terminals are once again making full contact with the solder pads on the circuit board.

You have to Press the Set button and then when Set 1 Date appears you have to watch very carefully where the
"blinking" is happening and then use the Up or Down button to make the setting. After each number change press "Set" and the blinking will move to the next value. Continue the steps until all dates and times are set.