Panasonic CT-27624CA TV chassis AP 335

it sounds that have problem in the chroma board ( video board ) a small board that hooked up in the neck of the picture tube. if the color is greenish the cause is dead in red video driver transistor or open resistance. hope this can help good luck.

It will be good to check the capacitor on the +B voltage that goes to the power section in the main board. A filter capacitor of about 47mF/160 V can be defective.
Next check the capacitor on the HT line to the grid-22mf/250V replace.
If possible loop on capacitors in the horizontal section particulary the IC.
Now the tip I can offer:
If the fault occurs on heating shcek out htis area to confirm and isolate the component.
But finally I understand that when you press any key the picture is good.If so check the memory IC/cmos IC in this section for logic control, it might be having a switching fault, a conflict or the video noise is coming on in default but goes off in the data selection mode. Do a soldering around this section on the IC , capacitor and see if the fault goes off or becomes irregular when this section is heated, if so there is a semiconductor producing this noise error .
So start from the begining so that we have a clean voltage inside.
I hope my advice helps.

cold solder in vertical ic

well this is weird try to do an auto program on what ever video you are using air / video okay se if this helps good luck

i need complete chassis for ct27sl15insertImage

turns on and off by itself

Maybe the vertical IC output are damaged you need to replace him

First, the blinking light is a code, how many blinks? Second, regulators are not resettable. Don

could be some bad solder connections on the crt socket or around the flyback area dealing with the brightness

check the ABL at the flyback. sould be at least 185+ volts on the G2 at the crt socket