Ant get hdmi to work - Mitsubishi WD-52531 Television

Antenna cable would go into ANT in
What cable did you use to connect box to tv.
I don't have the user manual so I am guessing that ANT out is for analogue channels 3 and 4 to go through to the tv. think
I suspect the coaxial out would go out to a video in type connection on the television.
If the Television has HDMI inputs I
you should go out and buy a HDMI cable and use HDMI out on the box.
Does the remote control for the box have a plastic strip in the battery compartment that stops the batteries. Or are batteries in the battery compartment.?

board replacement to repair

Hello
It seems to be some fault with its HDMI cable you connect to this device from the source. As you get sound by HDMI, and no picture at all, this indicates the fault with cable itself. There is a cution notice says that " To assure continued FCC compliance, the user must use a shielded video interface cable
with bonded ferrite cores at both ends, when using the PC or HDMI input."
Cheang the cable and check.

unplug HDMI cable, then re-connect them. sounds like poor connection.

Change the Scaler PCB CEF156A

Magnavox model # H2160MW9 A

You can do the initial setup by doing the following: Refer to the Owner's Manual channel settings
on page 31

Hi! I believe you have some concern on how to get good picture on your hd tv. I will be more than glad to assist u.. on your teac hdb841- there is a port connection - ant in, you have to connect the ant cable from your off the air tv antena to the ANT IN of the Teac HDB841. then on the back of your Teac HDB841, you have several output connection there like component, coax, s-video, rca and hdmi. since u have the hdtv u need to use the hdmi or the component cable whiich is the red blue and green then access the menu of the teac hdb841 and do a scan for the local channels.. ur tv should tune in to hdmi if u use hdmi cable or component if u use the red blue and green.. i hope this will fix the problem..

Please rephrase you get an "ant screen"?

Does the sound work? What is your hdmi video output device?

At any rate, you can also try this quick fix. In the setup menu go to Source Select. Make sure these settngs are right:

Assign>HDMI = HDMI 1 - 4 (depending on device)
Input Mode>Input Mode = Auto
Decod Mode>Decode Moe = Auto
Other>Video Convert = On

Set this for sources (devices) you have connected to the hdmi.

Are you using an hdmi cord or av cables?