Question about RCA 20V500T 20" TV

RCA 20V500T HALF PICTURE AND SHUTSDOWN

I HAVE A RCA TV THAT SHOWS A HALF THE SCREEN AND IT TURNS OFF IN ABOUT 10 SEC. I REPLACED THE DIODE AND THE PROBLEM PERSIST ANY IDEA YOU HAVE

1 Answer

Luke

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Problem Solver:

An expert who has answered 5 questions.
Contributor
23 Answers

Try , Horizontal or Vertical output.

Posted on Aug 27, 2008

Add Your Answer

Upload

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

1 Answer

Why does it turn from blue to black after 10 sec.?

Back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis.
http://electro-medical.blogspot.com/
http://electronicshelponline.blogspot.com/
To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced.

Dec 15, 2015 | RCA Televison & Video

1 Answer

Only half rca tv screen shows up

I think you may have a tv tube problem...

Jan 26, 2014 | Televison & Video

1 Answer

Power botton flashes but will not come on

my rca 52 projection tv started to shut off on its own
after some research I pulled the main board and replaced
three capacetors that looked suspect replaced board and tv
worked fine for 3 days and went out again any suggestion.

Aug 20, 2012 | RCA D52W135D 52 in. TV/DVD Combo

1 Answer

The tv wont light up

1) test the power supply , see the blown fuse or c.breaker tripped and reset.
2) Proof again, if the problem persist the problem arise with the power supply, some diode, capacitor, resistor, etc can be open or short. repair.test the power cord too, and main switch for open
3( see the diagram .God bless you

Jul 12, 2012 | RCA F36650 36" TV

1 Answer

The screen only shows the bottom half of the picture. I have a RCA TruFlat 27" TV and it has a horizontal line in the middle & only shows the lower half of the picture. I've smacked it a...

The problem of your tv is only a loosed solder.Remove the back cover of your tv but be sure to unplug it then try to look the solder part of your tv look for some loosed solder then try to resolder it using a soldering iron but be sure not to connect separated pin in the pcb.

Jul 05, 2011 | RCA TruFlat 27F520T 27" TV

1 Answer

I have a 32" RCA tv that comes on and turns off all by itself and it's a 2008 model

Replace the DZ03 (10-volt zener diode) to stop this problem.

Jul 03, 2010 | RCA Televison & Video

1 Answer

WS-65513 65 in. Rear Projection HDTV Television: My 65 inch Mitsubishi tv turns off a couple of sec...

The power supply will need to be replaced.

May 07, 2010 | Mitsubishi WS-65513 65" Rear Projection...

1 Answer

42" LCD tv shows picture on only half of the screen,other half dark!

The T-Con board (otherwise known as LVDS) connects to two seperste parts of the LCD panel. If you do have half a picture (left or right) replacing the T-Con board should resolve this issue. Open your TV, find the part number and search on eBay or at sites like www.flattvparts.co.uk where you can search by TV model number.

Oct 27, 2008 | RCA L26WD26D 26 in. LCD TV

3 Answers