Colored, pixilated bars appear during playback

try camera menu (change some settings )

may be silly, but check on left of cam there are three switches. middle one says output. is it on cam or bars? Hope it helps

Hi,If you are experimenting vertical lines ,black bars ,color

distortion,pixilation,or white dots on the screen you might be having an

issue with the Dmd chip.This is how the DMD chip works:

http://electronics.howstuffworks.com/dlp1.htm Basically the dmd chip

is composed of around 2 million pixels that create the image on the

screen.You will need to replace in order to fix your problem.Have a

blessed one!

My advice is that you should by a DV cleaning cassette. Put this in the camera and run it for 10 to 20 seconds only. running the cleaning cassette for a long time may damage the head.
good luck!
Luwangula

make it 16-bit instead of 12 bit

The monitor you view while recording does not read from the tape where the problem is located, that's why you are not seeing them during recording.
Since they are not visible while recording, the video section is healthy, only the recording is faulty and it is unlikely you can do anything at home to correct it.
This may be a common problem and perhaps Canon is familiar with it.
I recommend you call their service line directly:

email: https://www.usa.canon.com/consumer/controller?act=SupportMailerAct&fcategoryid=227&modelid=12812

Phone: In the US: 1 (800) 828-4040

If the heads become dirty, “NEED HEAD
CLEANING” appears during recording. During
playback, moreover, the following symptoms
appear.
≥Mosaic-like noise appears partially or the
sound is interrupted.
≥Black or blue mosaic-like horizontal stripes
appear.

When normal playback cannot be performed
even after the head cleaning
One possible cause is that normal recording
could not be performed because the heads were
dirty at the time of recording. Clean the heads,
and perform recording and playback again. If
normal playback can be performed, the heads are
clean. Before an important recording, be sure to
conduct a test recording to make sure that normal
recording can be performed.
≥If the heads become dirty soon after cleaning,
the problem may be the tape. If so, try another
cassette.
≥During playback, the picture or sound may be
interrupted momentarily, but this is not a
malfunction of the Camcorder. (One possible
cause is that the playback is interrupted by dirt
or dust that momentarily adheres to the heads.)

try cleaning cassette or the head needs aligned

my canon zr 200 in playback is fine but when i turn it on to record i have multi colored bars on screen and wont record

Recording a movie of a subject that is brightly lit by the sun or some other very bright light source can cause vertical lines or bars to appear in the image during playback. This is due to a CCD phenomenon called "smearing." Note that lines or bars appear in movie images only, but not in snapshots. Smearing does not indicate malfunction of the camera.