My pelco DVXe dvr display is at minimum not 32 bit cant see pics

canopus dv strom xa (dvxe-1) editing card is supporting graphic card number is asus eah4350 and 1 gb graphic on board is very suitable if doesnot suite the card call me +91 9010016553
from babucreations andhrapradesh india

If all of the 6 DVRs are on the same location (on the same network), and you want to remotely connect (VPN) to that location, you can Endura Enable the DVRs and then VPN to the Primary DVR. (Note that you need to be Endura Certified to use the Endura Enabled feature).
If they're all geographically distributed, you can only VPN into a single unite at a time..

on the cameras them self there should be a adress and baud rate setting this should be the same as what you have on the software. also the cable that you have going back to your ethernet panel cannot be by any electric lighting or anything like that and check and make sure that the connetors that plug in to the panel have the right color code. you need to look for the straight through wiring diagram 568b. hope this helps.

No deed of various software. But you have to have .net framework 2sps and .net framework 3.
Download from here.

Its compatible with Windows Server 2003; Windows Server 2008; Windows Vista; Windows XP

You need Windows Installer 3.1(v2)
or Windows Installer 4.5
Its good to have .NetFW 2.0 SP1
or
.NetFW 3.0 Recommended
Upgrade it to SP1

.NetFW 3.5
.NetFW 3.5 SP1
All of these are 32 bit packages and if you want any 64 bit package, go to Microsoft.
Other Requirements. - HW

Processor: 400 MHz Pentium processor or equivalent (Minimum); 1GHz Pentium processor or equivalent (Recommended)

RAM:96 MB (Minimum); 256 MB (Recommended)

Hard Disk: Up to 500 MB of available space may be required

CD or DVD Drive: Not required

Display: 800 x 600, 256 colors (Minimum); 1024 x 768 high color, 32-bit (Recommended)

Please be kind enough to rate this answer.
Enjoy.
Best of Luck
:)

pls add one of addisnal usb hdd in your pelco dx8000

Go to control panel- Display settings- See if Colour mode is 32 bit & 256 colours. try to change the display settings.

Otherwise uninstall- reinstall or upgrade thee display drivers using the Drivers disc or from HP website.

Try system restore if happened recently

yes, on the configuratiion plage, use the schedule to increase the amount of time you want for

1) Sechedule recording
2) motion recording
3) event recording.

Remember, this is all based on the size of your hard drive and the number of camera you have installed.

You can connect it to your PC directly with a cross-over net cable, and you also connect it to your LAN with straight net cable. Type The default address: 192.168.2.108:8004 in your IE after you set your pc address in the same geteway, you will see the user and PW requirement screen. if you can't get this screen,try to reset DVR to default setting. see Page#100 of its manual.

This DVR dose not support that...You can either see one camera full screen or see all 4 in a quad screen depending on how many cameras you have and how may of them are enabled.
If the Preview feature in the Camera menu is On, you can view live video on the monitor.
Video is displayed full-screen only if one camera is turned on. If more than one camera is
turned on, video is shown in a quad view. Sorry but its not going to be able to do what you are looking for...Pelco didn’t put that feature in their small DVR until the DX4000 series......Good Luck and let me know if this helps,

cbinny1