Where is waste toner on kyocera 1820

You need to replace the procces unit. The waste toner can not be emptyed the unit needs to be replaced, Some times if you remove the proccess unit and gentally shake it left to right several times and place the unit back in the copier the error will clear, if not you will need to replace the process unit which is a PU-102.

remove the drum unit. on the part of the unit that goes first in machine is the is waste toner container. on each side of the container there is a screw, remove one screw and pull out the cover. slant the unit and the waste will come out

this a drum unit related problem. empty the waste toner and the error will reset automatically

this is drum related error. empty waste toner from the drum unit

This is going to be messy, so do it outdoors.

Remove the entire drum unit. Remove toner cart

Remove the chrome screw on the right side and the cap.

Dump.

Install and reset power.

Hello sir; The code you display which means waste toner bottle full, just dump it .

You can empty the waste chamber on the image unit by removing the screw from both ends of the unit, pull the ends off and empty it out. It's a messy job so have a good plastic bag and a toner vacuum if possible. The message might stay on awhile but will disappear with time. The alternative is a new image unit.$$$$$$

Open the front cover and locate the waste toner bottle. Empty it out and see if that corrects the problem. If that doesn't work, clean the bottle after emptying it. If the doesn't work, replace the waste toner bottle with a new one.

How does the copy quality look?

open the front cover, pull out the process unit... then unscrew the left side of the waste disposal tank (the opposite end of the toner cartridge)

Apologies for the late reply. This is a waste toner full problem. Pull out the process unit (in case you don't know, it's the big black unit where you fit your toner into, also the one that you need to remove to check for paper jams. Turn it around so that the side where the toner fits is furthest away from you. Now on the side closest to you, on both the left and right hand side are two small covers, each fastened with 1 screw, hidden in deep holes. Remove these screws and covers, and empty the toner inside.

Be advised that this is a very messy job. Also, after you've removed these covers and you turn the unit on its side, the toner may not fall out. in this case stick a screwdriver or something in there to loosen the toner.

When done, refit the covers, place the unit back into the machine, restart the machine, and thats it. If the code still appears, you've got toner on the waste toner full sensor, which sits just above where the waste toner part of the process unit is, inside the machine. you can take a cloth and wipe this. although this is highly unlikely, nothing in this industry surprises me anymore.

if this still fails, you could have a faulty sensor or circuit board, but again, highly unlikely

have fun (nothin like gettin your hands dirty) ;)