Question about Maytag MAT13MN Top Load Washer

1 Answer

Leak from maytag top load coin machine during spin drain cycle only

Water leaks from bottom during spin drain cycle out bottom of washing machine not from hoses. this is coin op model seems fairly old (20 years? ) maybe [email protected]

Posted by on

  • 16 more comments 
  • Anonymous Mar 19, 2008

    leak out bottom

  • Anonymous Mar 16, 2014

    My machine has recently started to leak a small amount water from the bottom . I have checked the hoses and they seem fine. Also after finishing the final spin drying cycle when I rock the bowl there is a sloshing sound .Is this normal to have some residual water left in machine.

  • Anonymous Mar 16, 2014

    water is leaking from the washing machine not the drain

  • Anonymous Mar 19, 2014

    machine was in rinse cycle when noticed waterr coming out of machine at the front bottom edge. turned machine off and leak quit

  • Anonymous Mar 19, 2014

    coin operated top load wahser mat 14csaww does not complete

  • Anonymous Mar 20, 2014

    machine screams during entire spin cycle

  • Anonymous Mar 21, 2014

    maytag performa washer is leaking from the bottom and is noisy during the wash rinse and spin cycle

  • Anonymous Mar 22, 2014

    leaking water from bottom of machine when filling up

  • Anonymous Mar 23, 2014

    I have a Maytag PAV 3200 - it won't DRAIN. Was told to check the filters & the drainage?
    Need to know where the filters are located (obviously one will need to remove the sides of the machine) & I assume that the drainage area, will be at the end of the drainage hose?

  • Anonymous Mar 23, 2014

    leaks during wash cycle at bottom of tub

  • Anonymous Mar 23, 2014

    would not drain or spin. I have manually drained it and cleaned out filter, although there was very little in it. Retried spin cycle. Now anti flooding alarm is on. Looked at back of machine - nothing much of notr (slight leak around outlet hose but all drains free). Please help - all school uniforms in there!

  • Anonymous Mar 23, 2014

    Water leaks from the bottom of the machine

  • Anonymous Mar 24, 2014

    Washer will spin but water does not drain out

  • Anonymous Mar 27, 2014

    water is draining slowly in every cycle...

  • Anonymous Mar 27, 2014

    No water coming in but will run on spin. Add water by hose into the tub and it runs. Replaced control timer with no difference. No hot or cold water coming in. Is it the level control switch or the temperature control switch? Washer probably used 20 times in last 2 years.

  • Anonymous Mar 27, 2014

    water appears to not go to the drain

  • Anonymous Mar 30, 2014

    at the end of the wash cycle, water is leaking from the bottom of the machine

  • Anonymous Apr 01, 2014

    water leaks out from hose area, hose does not have a hole in it.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 240 Answers

Possible that you would have a tub seal leak if it is only noticable during spin cycle. Possible that it "drips" slightly while in agitation, but not enough to notice it. While in spin mode you have a lot more parts moving as well as a lot more water pressure on the seal itself. Pump could also be leaking, but highly doubtful since it would leak a constant amount at all times. Good Luck!!! Jim

Posted on Sep 09, 2007


1 Suggested Answer



Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does it leak all over floor after last spin cycle?

my washing machine leaks water onto the floor during each spin ...
Feb 3, 2010 - During drain and spin only A washer that leaks only during the spin cycle often has a leak in the main drain hose. ... It happened to us due to over loading. ...something can get betwen the two tubs it this all fails your tub seal is ...

Sep 30, 2015 | Kenmore Elite Oasis 27052 Top Load Washer

1 Answer

Mav4757aww leaks water during spin cycle with full loads only

Thanks for the quick responses.Pulled front cover,ran a load on high level, no leaks .Ran a load on super level and when drum spins when full of water water level rose and poured out of left front side on top of drum. Pulled plastic ring on top of drum and and found piece of seal missing where leak occured .Ordered upper tub seal, should solve problem

Jul 27, 2012 | Maytag Ensignia MAV4757AWW Top Load Washer

1 Answer

Water leaking from my Maytag Neptune model FAV6800AWW Serial number 15646382GA Leaks during wash cycle imediately and during complete cycle. Enough water to saturate 2-3 towels and clothes come out...

Could be a Tub Seal leak my 1st choice. Could also be a leak caused by a cracked outer tub, issues from the hoses from the drain line connections to the drain pump, drain pump and or drain line.

Are you going to try to DIY the fix?

Sep 07, 2011 | Maytag Neptune FAV6800AW Top Load Washer

1 Answer

Water coming out of the botton during spin cycle

Take the bottom panel off the waher, put water in the machine, and watch to see where it is leaking. If you don't see a leak during the regular cycle, put the machine in drain and spin mode, and watch for leaks there. You should find your leak during one of these cycles so you will know what part you need.

Feb 03, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Leaking from the bottom during the spin cycle

i would check the drain hose as well as any gaskets/seals for malfuctioning

Nov 06, 2009 | Maytag PAV2300 Top Load Washer

1 Answer


i would inspect both the hoses on the pump
no leak during cycle is explained because water is moving through them to fast to leak when the machine settles it starts to leak

Oct 15, 2009 | Hotpoint Aquarius WD63 Front Load...

1 Answer


The pumps usually have rubber hoses fitted them and they can deteriorate over time, moreso around the clamps that hold them onto the pump. Also, maybe the pump has been slightly opened via a worn seal. Either way, there may be a risk of fire if any water gets onto the electrical connections of the pump or spray onto any other open electrical connection inside the machine. It would certainly be advisable to have it checked with some urgency.

During the final rinse and spin, I would think the pump may not be used during these cycles.

Hope this helps somewhat.

Sep 14, 2008 | Whirlpool WTW6400SW Top Load Washer

1 Answer

Washer leaking water from bottom

Probably a main tub seal, big job!

Nov 16, 2007 | Maytag MAV7600 Top Load Washer

Not finding what you are looking for?
Maytag MAT13MN Top Load Washer Logo

870 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

Bill Long

Level 3 Expert

606 Answers

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Brad Brown

Level 3 Expert

18165 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides