Question about Kenmore Oasis HE 27082 Top Load Washer
When trying to set washing machine to any setting (Express, Normal, Whites, Etc.), when I press start, the machine defaults to 60 minutes and the setting for cleaning the washing machine. Also the beeper signal will not stop beeping. Is there a way to reset the control panel before I call a tech out. Purchased this machine is April 2006. Thanks so much for any advise. Edawg
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Sep 17, 2015 | Washing Machines
Jan 13, 2014 | Washing Machines
Jun 22, 2013 | Washing Machines
My EWD1477 was doing this a year ago and I fixed it. Then it started
doing it again a month ago and I seem to have cleared it again.
Firstly, remove the drain hose from where it is inserted into a laundry
sink hole to make sure it is not blocked or sealed in with sludge.
Secondly, make sure the machine is empty of water and clothes and then turn
the machine to off with the Program Selector Dial. Then turn off the power at
the socket and remove the power plug and leave for five minutes.
Step 1: put the plug back in and turn the power back on.
Step 2: turn the selector switch to the right (Whites/Intensive). The green light of the Start/Pause button
should be flashing and the green lights on for Prewash/wash, Rinses and
Spinning. Don't press any other buttons or change any other settings.
Step 3: press the Start/Pause button and wait for the machine to empty
any excess water. Press it again immediately after you hear water flowing into
the machine OR two audible clicks. The machine is now in pause mode with the
green light of the Start/Pause button flashing. Only the green light on the Prewash/Wash
button should be on. Leave it in pause mode for 30 minutes and then press the Start/Pause
button to recommence the cycle.
Step 4: If the Start/Pause button begins flashing, water stops flowing
into the machine and the three green lights mentioned above are back on, turn
the Program Selector Dial back to off, wait 10 seconds, and repeat the process
Step 5: If when you then turn the Program Selector Dial to
Whites/Intensive and hear the two audible clicks, immediately press the
Start/Pause button to set the machine in pause mode. Wait 30 minutes. Then
press the Start/Pause button to recommence the cycle.
Hopefully the cycle will run without a problem.
Mar 26, 2011 | Electrolux Washing Machines
Oct 23, 2010 | Bosch Washing Machines
Feb 01, 2010 | Kenmore 22422 Top Load Washer
Oct 17, 2009 | Bosch Classixx WFL 2066 Front Load Washer
Dec 01, 2008 | Kenmore Elite 45986 Front Load Washer
104 people viewed this question
Usually answered in minutes!