An expert who has achieved level 3 by getting 1000 points
All-Star:
An expert that got 10 achievements.
MVP:
An expert that got 5 achievements.
Genius:
An expert who has answered 1,000 questions.
Master
1,139 Answers
Re: my jensen lcd tv
It sounds like you need to reset this device to original specs. This can be done by leaving it unplugger for 4 - 5 hours.
Then is this does not work you will have to contact the company and get aa schematic. At that point we can begin troubleshooting.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
What do you mean by this blank screen. A screen with back light only? A screen without any back light [dark screen]? Provide more details please. If you wish to get details about these type of faults to Sony LCD TVs, check this link.
Open the OSD menu and select Channels with the left/right arrows and press Enter. Next, go down in the list and highlight Auto Channel Search. Press Enter. Then use the up/down arrows to get Antenna as the highlighted selection. Press Enter again. You should see the progress as the unit goes through the OTA channels. Press Exit to get out of the Menu when the scan is finished.
You will either have a fault with the inverter board which drives the backlights or a faulty backlight in the screen. If the problem is a backlight then a replacement screen is the only cure. One or the other is breaking down after it has been opn for a certain period of time, have an engineer call out & check with a tester if it is a screen problem.
white screen: 1.if ringtone is working but it has no display replace iether lcd or display i.c. 2.if there is no tone,no display and cannot turn off the light in morethan a minute it is called "hang up" and that is software problem.solution reformat or reprogram.
Sounds like Nikon are just trying to get out of fixing it. Have you read the terms of the warranty. If the screen is not working then it is more than likely an electronic fault and they are covered by the warranty. The only way the screen would not be covered is if it was damaged by the owner. The screen is part of the camera and therefore comes under the warranty, unless it specifically states that it is not covered in the warranty. Ask a consumer rights department. Don't take no for an answer.
how do I program my channels in
×