I need the codes for two Remote Controllers - models 15-2104 and 15-1992.

If you choose the correct codes from your remote controllers listing, I expect so.

hellow sir

ck for a fuse in the under the hood fuse box that says bsm may be blown.
Also try this.....
To reset the security system remove the negative battery cable for 30 minutes, then reconnect the cable. Next, lock and unlock the doors using the remote. This will reset the alarm system and the engine will start and fobs reset.

Here are some factory notes....FYI

Anti-Theft Systems

PROGRAMMING

NOTE: If a new Smart Entrance Control Module (SECU) is installed, a new identity code must be entered and all remote controllers must be programmed. If identity code cannot be entered, repair multi-remote system. See appropriate MULTI-REMOTE CONTROL SYSTEMS article.

PROGRAMMING > PROGRAMING NEW ID CODE

NOTE: This procedure will erase all previous identity codes and render all previously programmed remote controllers inoperative (until reprogrammed). All remote controllers to be used with system must be programmed at the same time. A maximum of 4 remote controllers can be programmed. Any attempt to program more than 4 controllers will be ignored. If same identity code is entered more than once, entry is ignored even though hazard warning lights will still flash twice.
1. Close and lock all doors. Erase original identity code(s) by inserting and completely removing key from ignition switch more than 6 times within 10 seconds. Hazard warning lights should flash twice. Turn ignition switch to ACC position.
2. Push any button on new remote controller once. Hazard warning lights should flash twice, indicating identity code has been entered. If identity code cannot be entered, repair multi-remote system. See appropriate MULTI-REMOTE CONTROL SYSTEMS article.
3. For each additional remote controller to be programmed, manually release door lock and lock again by using door panel switch and repeat step 2. If no additional remote controllers are to be used, exit programming mode by unlocking and opening driver's door.

Please let me know if you need anything else to get the problem fixed. Happy mew Year!

Please check with the links below for codes and help on remote controllers:

http://www.fixya.com/support/r6178946-tips_repair_remote_controller

remote control codes:

http://www.espares.co.uk/search/remote-controls/p/1090?utm_campaign=06-2011+unlimited+credit+1st&utm_medium=email&utm_source=emails ........ search for models of all types

http://www.xdiv.com/remotes/

http://www.hifi-remote.com/ofa/codes-tv.shtml

Codes and programing info here:
http://www.docstoc.com/docs/23925020/Programming-Remote-Control-Brand-Codes-TV-Sets

Might also be the last three or four digits in the TV's serial number.(like my ATD TV)

On some controllers you just have to hold the TV button till its light stays on, or whatever change happens, then enter the code, either three or four digits. You'll know after a few tries. If you get the right code the TV should either turn off or at least be controllable.

You didn't list a model number so I can't offer a direct link but you might try here if you have one:
Remotes

go here
http://www.x10.com/support/support_manuals.htm

the code will depend on the remote you're using. Each remote brand has their own code-sets.