Does not get hot - Rival VS230 Seal A Meal Vacuum Food Sealer

Sounds like hot and cold hoses are reversed.

Try switching the hot and cold hoses. See if the hot water works. Sometimes the gate gets frozen, other times the hot is so slow it seems to not be working, similar to when it takes a long time to get hot water in the sink.

Although the two names of drinks are used interchangeably, hot chocolate is a drink that's either made from real chocolate melted into milk or with packet hot chocolate powder. Cocoa powder is unsweetened and needs to be combined with sugar to create a sweeter drink.

In general hot chocolate is richer and sweeter than hot cocoa.

Screw terminals are color-coded on each switch. They vary by device.

Green screw always ground
Silver screw always neutral > except some 4 ways switches
Brass screw is hot > can be hot from breaker or hot wire going to load > or in 3-way switch can be hot traveler wires from other 3-way switch
Dark screw is hot > can be hot from breaker > or in 3-way switch is hot going to load

Single-pole switch:
2 brass screws > hot and load wires connect to either screw

3-way switch:
2 brass screws connect to travelers
dark screw goes to hot from breaker and hot to load

Switch-plug combo and pilot light switches:
dark screw goes to hot from breaker
silver screw to neutral, brass screw goes to load

Double switch:
dark screw goes to hot from breaker
brass screws each go to load

Receptacles:
brass screw goes to hot from breaker and to hot going to next receptacle
silver screw goes to neutral and to neutral going to next receptacle.

check to see if the cold tap is connected to the cold valve on the machine and the hot tap to the hot valve. on the machine it will have cold or c for the cold valve and hot or h for the hot valve. please reply if you need further help.

I have never heard of this before, and have always piped dishwashers off the hot water line. Not to say it could not be done the other way, I would refer to the instructions that came with the dishwasher, and if they say to connect to the hot water line, to have the technician come back and fix it. If it says to connect to cold water line, then manufacturers know best.....Hope this helps

Check the hot water line going to washer have hot water?If donot have trace the line from Hot water tank going to washer if yuo rfound it open the valve. hold the pipe you can feel the hotness.attache to machine.