P4mmv2 motherboard need t o know where the power/reset/hd led/ ect connection r on this board

Connect the front panel leads to the motherboard connector marked "JFP1" using the following pins as indicated by the markings on the motherboard and the front panel leads: HDD LED on Pins 1 and 3; power LED on Pins 2 and 4; reset switch on Pins 5 and 7; and the power switch on Pins 6 and 8.

Good luck.

just go to their website im sure they have the manual there, or find someone to help you out that have basic knowledge about computer board.

The various wires from the case front panel should be labeled to indicate power LED, HD LED, etc.
The motherboard front panel jumper pins should be grouped together and the pins should be labeled to indicate PWR, HD. RST etc.
You can go to the motherboard manufacture's WEB site to download a diagram of your model motherboard and it will show all the locations of the connecting pins.

get a magnifying glass where the cables plug in you will see letters,hd,led,reset ect....

Do you mean speaker or front panel audio? The front panel audio connector is located at the rear of the board, behind the PCI connectors - the speaker connections are in the panel connector block (2x10 pin header) located at the front left of the board.

With the board in it's normal position, the speaker pins are on the right hand side of that block, on the pin nearest the front and the one 3 positions behind that

<back of board>
|
|
| HD LED + | | Power LED +
| HD LED - | |
| | | Power LED -
| | |
| | |
| Power SW | |
| Power SW | | Speaker
| | |
| Reset SW | |
| Reset SW | | Speaker
|
------------------------------------------------------
Front of board

Hi,

Here is a link to your motherboard manual:

D845PEBT2 Manual

Go to Page 33 for the Front Panel connections...with pictures. :-)

Thanks for using Fixya.

If its a P4mmv2 motherboard with AMIBIOS 686 and a VIA VT8233 chipset then the jumper setting are printed on the motherboard, but they have labeled the power switch wrong, I believe th reset switch is the power switch. This is the type of mother board that I have and I have learned this from experience. Also I read in somewhere on the internet about the problems with these types of motherboards.

With the power on cross the pins with a slide on connector. When it fires on you know which one is the sw. When you cross the reset it will restart. When you try the HD the light will come on during HD activity. And the power light will work when you have the power light plugged. It isn't to hard. Just be careful.