My microphone doesn't do it right.

the green light is power indicator not mic level. the green light should come on when powered up. remove mike cable and the see if green light comes on, If it does power down and connect mike and cable (hopefully you have a good quality one and not a toy)
Call Behringercustomer service. Where did you buy it from, if new it is under warranty and need to replaced with another new one. It is not an audio mixer the yellow and right lights are for clipping.

Greetings! Ok, your amp has an XLR (3-prong) Low-Impedance input on Channel 1 for a Mic. All the other inputs are 1/4" High Impedance inputs, which are for instruments and/or other High Impedance items including low quality High Impedance Microphones. The SM48S is a high quality Low Impedance microphone, so if you use it with a 1/4" plug, it will be in a High Impedance channel, and will be very LOW in volume in comparison with everything else. So, you must use an XLR (3 prong) cable from the Mic to the Channel 1 input on your amp. That will do the trick. Good Luck with your new amp and Mic!

Here's the manual. page 8 Good Luck!




http://ec1.images-amazon.com/media/i3d/01/A/man-migrate/MANUAL000064843.pdf

That's a condenser microphone. Make sure you have on your phantom power. Should be a button or switch somewhere on the mixer ( individual channel or switch by power switch or in master section for +48v). All condenser mics require this.

It is likely that the brown goes to pin 1 (ground/shield phantom -) as well as the black.

Red is likely to go to pin 2 (across from 1)(signal +)
and the orange to pin 3 (signal -)

It is right and it ease enough to replace OP AMPs, if you have an experience with surface mount components.

Hello and thank you for using Fixya's service.

The Podcaststudio may have bumped out your audio driver. This happens quite a bit. You can re-download the driver free of charge by visiting the manufacturer or your computer (ex. dell.com). Once on the page, click on support, enter model number and operating system. They will make available a list of drivers for your computer. Scroll down near the bottom and choose the audio driver. Download and install. Reboot the computer and you will be good to go.

Please let me know if you have any questions.

Here is the manual:http://www.behringer.com/EN/downloads/pdf/MIC2200_P0054_M_ENG.pdf Plug your microphone into the input using a proper cable. Plug another balanced cable into the output on the back and plug it into a microphone input on the mixing board. If your mixing board already has phantom power, disable it for that input as the MIC2200 has phantom power. Read the manual carefully and take note of the directions for phantom power and balanced cables. Make sure you follow the directions carefully. If you need the manual in a different language look the MIC2200 up under products at Behringer.com and you can download in pdf format in many different languges.

The microphone needs a phantom power supply to work. In your case you need a 48volt phantom power supply. Some mixers have this feature built in.The Micropower PS400 by Behringer would probably be a good choice.

I had a similar problem where as I could use the mic no problem at all but couldn't hear anything through the headphones. The simple solution was to disable the driver for my internal soundcard. It took me 48 hours to work it out! Good luck.