Question about JVC AV-32D305 32" TV

2 Answers

Just bought a 32" LCD HDTV from a guy, it worked great for a week

But now all I get is a blinking power light and a couple clicks when I try to turn it on. any ideas, besides i got screwed? It was manufactured in may of 2007

Posted by on

Ad

2 Answers

The Power supply was the problem! I had it fixed for $200 at a local shop and has been working for about 3 months so far so good! thanks for the reply!

Posted on Dec 29, 2007

Ad

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

From another post made on here, it sounds like the power supply in the TV got fried. Most likely hard to fix if not impossible. I would probably junk it, fixing power supplies are hard I know I've tried to fix pc ones and it only worked once for a little bit lol so unless you are technically inclined and handy with a soldering iron or know a buddy who is, you probably shouldn't bother.

- Dave

Posted on Dec 28, 2007

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Panasonic Viera. The TV went off & I got 4 blinking red lights. Installed new power supply. I plugged it in & it made 2 clicks but still will not turn on. I'm still getting 4 blinking lights.Any ideas


Great set - you were on the right track but ........
U will have to do what I did on these new sets. Google has dynamite blogs on the workings of these sets, what each board does, and what are the symptoms of a problematic board. Knowing exactly what your tv is doing and not doing you can use these guides as a wonderful way of finding out what other boards could be at fault besides just your power supply. U have nothing to lose and all to gain with the free info. Good luck.

Aug 31, 2015 | Panasonic Televison & Video

1 Answer

Hi, I have a Sony KDL-46XBR9 LCD Digital Color TV. This morning my son was watching cartoons and it clicked itself off. It has sometimes done this in the past, so we did something else for a couple of...


This tv have a power supply board is the causes and the problems.Ur tv power supply board finally gave out and not supply the right voltages to the tv system anymore.That the board,where the tv power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

Dec 06, 2010 | Televison & Video

1 Answer

In my WS 65809 projector tv, when I turn on the power, the green light clicks on for a couple of seconds, then clicks right back off.


DO THIS AND LET ME KNOW WHAT YOU FIND:

Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} MOST OF THESE SETS HAVE A SELF DIAGNOSTIC:

UNPLUG TV AND THEN PLUG BACK IN---TURN ON---GREEN POWER LIGHT COMES ON FOR A MOMENT AND GOES OFF.

PRESS AND HOLD “device” and “menu” buttons on front of tv for at least 5 seconds and then release both together.


Watch for power light to blink in a sequence:

1 blink-then 2 blinks-------no error

2 blink-then 1 blink-------X-ray protection

2 blink-then 2 blink-------SHORT PROTECTION*******

2 blink-then 3 blink---------deflection circuit problem

2 blink-then 4 blink---------vertical circuit problem


******2, then 2 is most common---usually means one of the fuses that protect the Convergence IC or IC’s is blown---set will detect no voltage to convergence IC and shut down.


SET WILL REPEAT BLINK ERROR CODE UP TO 5 TIMES AND THEN TO GET IT TO REPEAT MORE YOU HAVE TO UNPLUG SET AND TRY TO TURN ON AGAIN.


IF IT IS 2 AND THEN 2---USUALLY
CONVERGENCE CIRCUIT PROBLEM

If this information has helped you rate this solution as I do this here for free.

SD TECH

Dec 06, 2009 | Mitsubishi WS-65809 65" Rear Projection...

1 Answer

Sharp LC-26D43U TV. After power is turned on the power light comes on for a couple of seconds and then there is a click and the power light blinks 4 times then pauses and repeats the 4 blink sequence......


Power board is detecting an 'over-or-under-voltage' condition from other circuits. Could also be high dc volt shut-down. In either case, the tv is in protection mode to stop further damage this is why it flash an error code 4 times. Each number flash intervals tells the tv-technician what area the fault may potentially be. take it back if its under warranty, or have a repair shop near you fix it.

Nov 20, 2009 | Sharp LC-26D43U Television

1 Answer

Acer Aspire One Netbook ZG5 will not turn on


you should be able to press ESC to exit hibernation, or remove the battery, remove the plug, press and hold the power button for 60 sec, and reinsert battery and power and turn on. when restarted, right click on desktop, click properties, and click the screen aver tab, click the power button, click advanced, and remove the check box beside enable hibernation on the "Hibernation" tab. it shouldn't do it again

Apr 20, 2009 | Acer Aspire One Netbook 8.9" Notebook

1 Answer

Printerndoes not respond


I thought my printer died on me, but it turned out it was a simple paper jam. The whole printer just locked up because of a paper jam! All I had to do was open the top compartment, remove the toner and get rid of the paper jam

Jul 25, 2008 | HP LaserJet 1320n Printer

2 Answers

Green Light Blinks But Does'nt Turn On...


It sounds as though your lens is jammed. The clicking sound is likely the camera trying to open the lens and failing, then it turns itself off. Check with your manufacturer for recalls and technical bullitins. See if they will service the camera under warranty. If you cannot get it serviced economicly at the factory there are repair services on the internet who will work on your camera. David Millier Advance Camera Repair

Mar 02, 2007 | Samsung Digimax S600 Digital Camera

1 Answer

Hitachi 32HDL51 Problem


i had the same problem a couple day ago u have to just connect both cables connecing tv and the power box

Sep 17, 2006 | Hitachi 32HDL51 32 in. HD-Ready LCD...

Not finding what you are looking for?
JVC AV-32D305 32" TV Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76237 Answers

Todd Hill
Todd Hill

Level 2 Expert

433 Answers

matt martin
matt martin

Level 3 Expert

1257 Answers

Are you a JVC Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...