DAEWOO,WASHING MACHINE.CDW-WD13WCS/RCS. Door will

As these manufacturers use the same type board in their machines, video will help you

According to the service manual,

Daewoo Washing Machine Error Fault Code = LE
Fault Detected: Washing Machine Door Open
Washer Has Detected: Washing machine detected door as open or not locked
Check / Repair / Fix = Close door – Door lock switch – Door latch – PCB

5.5 Opening The Door (from user manual)

While a program or the 'Delay Start' is
operating, the appliance door is locked and
the display shows the indicator 'key symbol '.
First set the machine to PAUSE by pressing
the "Start/Pause" touchpad. Wait until the
door lock indicator 'the key symbol ' goes off, then the
door can be opened.
If the door lock indicator 'the key symbol ' does not
disappear, this means that the machine is
already heating and the water level is above
the bottom edge of the door or the drum is
turning. In this case the door CAN NOT be
opened.
If you can not open the door but
you need to open it you have to
switch the machine off by turn the
program selector knob to the
position " 0 " to deactivate the
appliance. After about 5 minutes the
door can be opened.
CAUTION !
Pay attention to the water level and water temperature.

Dado

OE means uneven load.
If you can open door, put a dry towel in with the washing and try spinning again ...

Watch this video Its content all error code and solution

Use a tooth brush. If there is lime scale use a descaler

LE Washing machine door opening error
The washing machine or washer dryer door has been detected as open or unlocked.
·Close the door!
·Check the door lock switch
·Check the door latch
·Check PCB

Hello & Welcome to FixYa

OE is a drain error and is displayed when the washer is unable to drain water. Please check the drain hose and drain pump filter for any clogs to clean the error. Please get back to me if you have any other questions.

Kevin

my daewoo washing machine has error code LE
after every wash , it cannot rinse and spin then show
beep sound and show code LE. Thank you

Just got the same problem. Found out there is a filter on the bottom of the machin that collects everything. It was plugged bad. There is a door on the front bottom left open door unscrew filter (the bigger object in the door.) Clean filter and wala.