My TV turns off by itself with OCP error message appearing

Hi,
This kind of symptoms appears when System Control IC have cold solder joints. Please check below picture mentioned IC101 to be resold in your TV main board.



If you have good soldering skills and familiar with TV, you can do it at your own.
Good luck.

B+ over current protection (OCP), unit goes to the standby mode then displays the 2 blink fault. Could be a short in the power supply of any of the circuits.

you'll need to do a master reset of the device

check link -->

www.retrevo.com/support/Vizio-L32-TVs-manual/id/512dj084/t/2

B+ over current protection (OCP), unit goes to the standby mode then displays the 2 blink fault. Could be a short in the power supply of any of the circuits.

Hi

This error means there is an internal error condition. To resolve this error remove the cartridges from your printer. Now wait for message "Insert the cartridges' to appear on the printer, as soon as the message appears disconnect the power cord from back of the printer. (Restart the printer if message doesn't appear) Now wait for a minute and plug back the power cord, if doesn't turns on itself then press the power button.

Insert the cartridges and check whether you are still getting the same error. If you are still getting the same error then try pressing # and 9 key simultaneously to reset the printer, wait for a while to let the printer complete the reset.

Daniel Scott

I have the same problem. I can get the video by pushing the power button on top of the TV after using the remote and getting the power and ocp light dance.

The message appears when force has been applied to the lens. You will probably need service.

According to Sharp it is a software problem. Engineer came, installed software update ,10 minute job.....TV worked fine for 1/2 day unfortunately: Then images turned black and white in all channels TV turned itself off, and stanby and OPC buttons started flashing. When TV came back on its own 10 mins later , screen had 2 large square staines superimposed in image (as if it was a burnt screen)...Engineer will be back next week...all quite sad really for a new TV.....will keep u posted

Hey Wiggs12485,
This error message appears when the camera detects a problem with the lens when it's turned on. This is often caused by the user pressing on the lens when it is trying to extend, or the camera is being used in a dusty or sandy environment. When this message appears turn the camera off and back on, and this should resolve your issue. If this message continues to appear you should have the camera looked at by an authorized service technician because there is probably a problem with the lens.

Sincerely,
Allan
Go Ahead. Use Us.