Flashing loc code and it will not start at all.

H00 No abnormality detected - Normal operation

You may have a problem with the outdoor controller, the indoor controller or both. Power outages can do some strange things to the electronics. Turn the A/C isolator off for five minutes and back on again to be sure the problem is still there. You could also try this:

• To clear memorized error (Protective operation) status
after repair:
1. Turn power on.
2. Press the AUTO button for 5 seconds (A beep
receiving sound) on the main unit to operate the unit
at Forced Cooling Operation mode.
3. Press the CHECK button on the remote controller for
about 1 second with a pointed object to transmit
signal to main unit. A beep sound is heard from main
unit and the data is cleared.

send it back. sounds like memory or fan quit. beeps are failure codes and if you got in january then i would send back to be repaired. take your hard drive out if there is anything important on it because they will format if you dont pay for them to save data

WE used the broil button last night and our stove started beeping nonstop.It also say F1 three hrs of beeping we unpluged it for the night.When we turned it back on today same thing happened with the beeping and F1.hOW CAN WE FIX THIS?

This is an added extra and basically a new problem. Mine is brand new. I hold the left button down, and get the first beep, then hold the right button down, and it beeps multiple times, and stayes at 88. It took about 15-20 minutes of trying this before we got the 00. I think the lock mechanism is broken, as I can't get it locked either at the end, so I just let the system lock itself after 1 minute. We unplugged it and tried again, and still after multple time eventually got it to go to 00. I take it that this isn't normal.

Has your problem been solved?

plug it back in and press the cancel button

I pressed the lock icon on the panel and held it for a few seconds and the display cleared.

Hold down the number three button until the LOC message disappears and then the door will open.

This just happened to me. I have whirlpool double oven accubake. The display went blank and i had to turn the breaker off. I left it off for several hours. When I turned the breaker back on my oven display read "Loc" in big letters to the right of the time. I held the start button down for 5 secs. The display went away and the oven started to work as if nothing had happened. I hope that is stays that way.

Pressing the options and select buttons simultaneously for 5-10 seconds worked. For me it happened this way: on the first attempt, with the indicator lights already "timed-out" and off, pressing and holding the options and select buttons simultaneously for 5-10 seconds caused the lights to come back on and flash the "LOC" code again. But holding the options and select buttons together for 5-10 seconds a second time caused the indicator lights to stop flashing, and allowed me to start the cycle.