Power supply connection for pioneer eq-6500

If is a parametric equalizer is zero watts. ,pionner should have a front, rear and subwoofer connections. If i remenber correctly, a single rca going to your stereo and the rest from eq to amp or amps. Hope this helps ,hope you get WIRED.

need manual

Pioneer EQ-6500 9-Band Car Equalizer .i want to buy this equaliser.i need 10 pieces ,please send me through my email [email protected]

Go to pioneer.com/usa for the harness if it's still available they'll have it for about 20.00.

i need wiring diagram for a pioneer bp 650 eq

I need to see a diagram how or how to setup my equalizer and reverb to my amp all pioneers old stuff sg60 and sg540

POWER SOURCE
REMOTE
12VOLT POWER
GROUND//
AND RCA IN FROM DECK AND RCA OUT FROM EQ TO DECK

top left - orange.....goes to aux or memory wire
top right - blue.......goes to the remote wire used with amps
bottom left - black.......goes to the ground wire
bottom right - red........this goes to your hot wire

Blue goes to your head unit's blue wire. It switches the eq on when the head unit is switched on. It also gets tied into the amp's blue wire (if you are using an amp, and I guess you are since you have a passive eq...). The fact that there are 2 is just for conveinience I think (99% sure) If I recall one may have a white stripe, and the other none. If you want to be sure, with all power DISCONNECTED to everything, and the harness plugged into the EQ, use a multimeter to see if there is continuity (connection) between the 2 blue wires. Then you can rest assured they gave you a secind one just for a "pass thru" to your amps, but inside they are electrically connected, and are essentially the same piece of wire.

REMOTE POWER SOURCE IS HOOK