Question about Karbonn K9

1 Answer

Keypad karbann power key direct on then not working

Posted by shambhu on


1 Answer

Chayan Mahato

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Micromax q1+ invalid sim problem

Posted on Jul 14, 2013


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


Using Hardware Keys Step 1Press and hold the "Power" key to turn off the Xperia Play.

Step 2Remove the back cover, and then take the battery out of the phone. Leave the battery out of the phone for a few minutes, and then replace it and the cover.

Step 3Press and hold the "Left" and "Right" directional keys under the screen.

Step 4Press the "Power" key while holding the "Left" and "Right" directional keys. The Factory Data Reset menu displays.

Step 5Use the directional keys to highlight the "Factory Data Reset" option, and then press the "Power" key to select the option.

Step 6Follow the instructions to complete the data wipe. The device powers down, and then boots back up. When the Xperia Play turns back on, factory default settings and software are restored.

Sep 24, 2014 | Sony Xperia Play R800x

1 Answer

06 equinox wont start.

Did you check the relay? Maybe swap it with another and see if that works.

Feb 06, 2014 | Chevrolet Equinox Cars & Trucks

1 Answer

93 4.0L wrangler blower motor works when hot wired direct. No voltage at heater fuse mini-fuse box under dash? Where do I track voltage backward from there?

The 25amp blower fuse is powered thru the key switch.
Do you have power at the key switch for that circuit when it is in the on position ?

Apr 20, 2013 | 1993 Jeep Wrangler

1 Answer

Fuel pump doesn't come on with key. took it out and it works by direct power. can't find pump relay

fuel pump only comes on for 5 seconds when key is turned to ON, unless engine is running.
Relay is usually near PCM with power realy for PCM - computer.

Jul 14, 2011 | 1997 Lincoln Continental

1 Answer

The jet direct card is not showing up on the configuration page

Two possible problems:

1. Bad formatter, not liklely if you have used this printer with this jet direct card for a while and have not removed the card from the printer.

2. More likely either bad or in need of reset jet direct card. I am going out on a limb and guessing that you have a Jet Direct 615 card. There is a small chance that the card just needs to be reset. To do this you must perform a cold reset of the printer. Any custom tray settings that you have made will be lost during this process as will any network settings. To cold reset, turn printer off and unplug the network cable. Hold the "checkmark" key and power on the printer. Keep holding the key until all three leds turn on solid. Release the checkmark key and use the arrow keys until "COLD RESET" shows in the display. Press the checkmark key and until will perform a cold reset and restart. Plug your network cable back in and print a configuration page. If card is working again great, if not, it is likely that the card is dead and will require replacement.

If card does work, you will want to ensure that the Jet Direct card has current firmware on it. Use the HP Download Manager to update the firmware on your Jet Direct card.

Good Luck.

Apr 18, 2011 | HP LaserJet 4200 Printer

2 Answers

I need a code for a TV remote for a GPX TV

Comcast sez the code for GPX tv is 10179

Jan 16, 2011 | GPX Televison & Video

1 Answer

Down arrow key not working properply; cursor keeps moving up on its own: sometimes doesn't respond to down arrow key being pressed

u probably have sticky stuff and dirt in the directional pad, try this:take the battery out, make sure the power is off, pour a little alcohol in the the crack of the directional pad, then press the directional pad in the different directions to loosen it up, finally let the psp sit for a few hours til the alcohol dries (or blow in it) that sould loosen everything up, if that does not work you will have to open the unit and clean the pad thorougly... LS

I’m happy to help further over the phone at

Jul 13, 2009 | Sony PlayStation Portable (PSP) Console

1 Answer

Fax and copy problem

Does the All-In-One make a loud noise and then stalls.
If it does then it should also give a message as Scanner Failure.
Take out both the cartidges from the All-In-One and unplug the power cable directly from the All-In-One and move the carriage (carriage is the on which hold the cartridge) Too and Fro unitill you feel it is moving freely, Then insert the ink cartridges and close the access door, And plug the cable directly to wall outlet without surg protector, and before connecting the power cable to the printer press and hold the # and No 6 keys, without releasing the keys insert the power cord and after you see a window which says semiful reset you can release the keys.
And in case the screen goes blank then release the keys and turn the power On, on the All-In-One.

Good Luck.

Sep 01, 2008 | HP OfficeJet 6210 All-In-One InkJet...

4 Answers

Pioneer vsx-d814 will not power on after power surge

I pressed the front Enter and Advanced Surround for 2 seconds on my VSX-D814 and that worked. Thanks.

Mar 21, 2008 | Audio Players & Recorders

1 Answer

Yamaha dv-s5650

I have a Yamaha DV-S5550 and recently did the same thing. Our players may have the same menu system. Give this a try. Turn the power to the dvd player on. Using the remote, follow this key sequence exactly. Press the onscreen button. Press the down directional key once. Press the right directional key once. Press the down directional key six times. Press the right directional key once. Press the down directional key once. Press the left directional key once. Press the onscreen button. Your player should now be set to NTSC output. Good luck!

Feb 24, 2008 | Yamaha DV-S5650 DVD Player

Not finding what you are looking for?
Karbonn K9 Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Karbonn Cell Phones Experts

Tom Chichester

Level 3 Expert

55379 Answers

ray gallant

Level 3 Expert

67943 Answers

M.B. Nataraj
M.B. Nataraj

Level 2 Expert

97 Answers

Are you a Karbonn Cell Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides