I have direct tv with a LG TV-Built in DVD (Model 32LG400). In the past I was able to use my remote for switching between antenna, av mode, and controlling volume. If I wanted to watch a station on Direct TV I would utilized the Direct TV remote (very rarely) Tried to turn on tv this morning and LG remote is not working at all. Had to manually turn on TV because Direct TV remote is not programmed. I want to utilize LG remote under my attena. Please help.
SOURCE: LG LCD and LG DVD remote codes
If both units are LG you don't have to program anything. Below the power button are 6 buttons labeled TV, DVD, etc. As soon as you push the DVD button the remote should work it. Remember to push the TV button again to make it work the TV.
SOURCE: LG 42LC7D TV does not want to chg channels after 5 min of use
There are some inductors that are out of spec. LG's original SB said to replace some of these with a jumper, but it only lasted a couple months.
You need to have the Total Main Assy replaced.
SOURCE: LG TV 32LB9D VOLUME STUCK AT 100, NO RESPONSE TO REMOTES
The fault may be on the control board. Sometimes the button switches can be stuck, or there may be something causing some conduction on the control circuit board. It is also possible to have a component failure that is causing a continuous command to keep the volume to the high position.
Something that causes failures of controls in TV sets is when people clean the screen, they spray liquid cleaner on the screen. Some of it drips down in to the controls and on to the circuit board. This will usually cause damage, and thus the set will require shop service.
Jerry G.
SOURCE: LG DVD Remote to control TV
The procedure is simple. Hold down the TV POWER button and press a number botton. Release the TV POWER button. The manuel gives the following list of codes:
LG/GoldStar....1 (predetermined), 2
Zenith...1, 3, 4
Samsung... 6, 7
Siny... 8, 9
Hitachi... 4
I have an RCA and 6 worked for me.
-olivares1900
345 views
Usually answered in minutes!
×