SPEED OF TREADMILL ACCELERATES

Have an electronic evaluation carried out, it's quicker and in the long run safes you frustration and cash.

Knot is a measure of speed. Knot per hour is a measure of acceleration. Are you sure you want 49 knots per hour?

49 knots is about 56.4 miles per hour or about 90.7 kilometers per hour. A good pace for a car and a very good pace for a boat.

49 knots per hour is about 56.4 miles per hour per hour or about 90.7 kilometers per hour per hour. Not a very good performance if a car or a boat takes an hour to get up to that speed.

Dear Sir:_

I will try to help you.

Please check this:

It is simple to change your treadmill so it reads MPH.

Treadmills are an easy and relatively inexpensive way of maintaining physical fitness. Most modern treadmills have a readout on their console that will track your speed over time in kilometers per hour or miles per hour. If your treadmill came with the wrong setting, it is possible to toggle between these two settings.

Instructions
Things You'll Need

• Pencil

• 1

Switchthe power off without unplugging the machine. Do not take the safety key out ofits place.

• 2

Inspectthe bottom of your console. The calibration switch is in a small hole. Insertthe eraser end of a pencil into the hole and softly push the button. You willsee CL11 on your console after you push this button.

• 3

Usethe Speed + or - key to select MPH or KPH. Push the Power key to save yourselection.Sincerely.E.CUADRAMANAGUA, NICARAGUA C.A.

Generally the symptoms say the catalytic converter is clogged, you can't get any air out so you can't pull any air in, and the age of the vehicle says so too. Look and see if it has ever been replaced.

I lost the manual to the pro-form 520. How do you tighten the belt? Where can I order a new or find the on line manual?

[from my Owner's Manual]...
On MY Free Sprit mdl 309180:
1. Remove the safety tether from the treadmill.
2. Press POWER button and hold.
3. While pressing the POWER button, insert the safety tether.
4. After lights on the LED display go out, release POWER button. You will hear a beep.
5. Press POWER button again. You are now in kilometers per hour.
* Repeat steps 1 - 5 to convert to miles per hour.
* If you are in kilometers per hour mode, you will see a "Si" in the time section when the safety tether is inserted.
* If you are in the miles per hour mode, you will see a "bri" in the time section when the safety tether is inserted.

Hope this helps,

gyro_john in Saskatoon, SK Canada

It's in Miles The treadmill goes a max of 14km an hour - if you increase the speed it only goes to 8 - 14km per hour is 8.4 miles per hour and I've been running between 5.5 and 6.5 and covering 3 miles which would be about right :) Hope this helps

sound like transmission slipping .fuel filter clogged.turbo stop woking.dirty fuel injectors.

hey
at the begging u should clarify how many gallon u used.
112 miles at 28 miles per gallon --> 4 gallons burned (112/28)
So that means we leaked 11 - 4 = 7 gallons

Now figure out how long the car was driving.
112 miles at 64 miles per hour --> 1.75 hours

So, leak was at a rate of 7 gallons in 1.75 hours
7/1.75 = 4 gallons per hour leaked.