Just before losing the cursor, a little tab pops up with tiny writing that I cant read. Then after losing cursor and screen goes dark, i shake the mouse for quite a bit to get screen to come back on.
SOURCE: my cursor keeps freezing and
You may have broken a solder connector in the mouse when shaking it. Try a different mouse, if it doesn't happen with the new mouse you know the old on is the problem.
SOURCE: lose device and sound card cd
your drivers are available here http://www.asrock.com/mb/download.asp?Model=P4V88 download them to your desktop, unzip them to a folder you can find and install.
Regards..
SOURCE: Compaq Presario SR1520NX PC Desktop when i turn
quel fiche pour connecté je suis supossé branché & ou pour un power suply sur un compaq présario SR152ONX
SOURCE: computer acting crazy
Sounds like you might have a virus or infection that is causing it. Try
booting up into safe mode and see if the acts the same way. Turn off the computer, then hit the power button to
turn it
back on and immediately start hitting the F8 key repeatedly until you
see SAFE
MODE. Take the Safe Mode option and let it boot up. Safe Mode will look
different to you, the screen will be darker and the icons bigger, this
is
normal. If the system runs ok in safe mode then turn it off and reboot
as if you are going into safe mode again, but this time take the Safe
Mode With Networking option (this will give you internet connectivity).
When it boots up, open your browser and download and install
MalwareBytes, then run a Quick Scan. Go to www.google.com and in the search box type:
"Download cnet Malwarebytes" (without the quotes). Download and
install malwarebytes from the sites download.cnet/malwarebytes. When the
site opens up click on the Green Download button on the left. Do not
click the Red Download button, that's junk. When it finishes installing the Gui
Interface will open up with an offer to Accept a Trial Version or
Decline. CLICK DECLINE you want the totally free version. Run a
QUICK SCAN. As it scans, if it finds infections the number will be in
red. When it finishes scanning, click SHOW RESULTS. A notepad text
document will open up showing you the results. You can close the text
document and go back to the Gui Interface where you will click REMOVE SELECTED
RESULTS. The objects will already be selected for you. When it
finishes removing the objects click ok and it will sometimes reboot your
machine.
43 views
Usually answered in minutes!
×