Sony Grand WEGA KDF-55WF655 36" Rear Projection HDTV Logo

Question about Sony Grand WEGA KDF-55WF655 36" Rear Projection HDTV

1 Answer

55 in Sony KDF55WF655 Goes to standby and red light blinks 4 times

After turning on, TV powers up then goes to standby. The red light then blinks four times. The TV is a little less than 3 years old. This problem has gotten worse and now the TV will not operate. For the last two years the problem was intermitent and would be resolved by leaving TV for a few minutes. Any help appreciated.

Posted by zx12 guy on

  • zx12 guy Oct 10, 2007

    This did it. I replaced the H4 board, facing the TV on the lower right back, and it works now. Thanks for your help.

  • Anonymous Aug 16, 2008

    The picture shut off and there is a red light blinking after the green light light blinks

×

Ad

1 Answer

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 140 Answers

Check the thermal sensor fuse part# 1-910-023-93 or possibly one of the four fans. If the unit goes into Fan/Thermal Protect shutdown (4 blinks) it can be difficult to determine the cause since the unit turns off too quickly to troubleshoot. Solution: Ground the data line by inserting a jumper between pins 3 and 6 of CN44 on the H4 board. This overrides the protection circuits for troubleshooting. Do this right after turning the unit on and as soon as the lamp is seen lighting. Check pins 2, 5, 8, and 11 of CN6000 on the G2 board for less than 1VDC. Any voltage higher than that indicates a faulty fan. If all voltages are within specs, the H4 board must be replaced. If a fan is found defective, the optical block will need to be replaced if it is located inside the assembly. H4 Board Part Number: A1054674A Replace the following part based on which pin of CN6000 is out of specs: Pin 2: Fan 1 (part of optical block) Pin 5: Fan 2 178723211 Pin 8: Fan 3 178706511 Pin 11: Fan 4 178708111 Optical block Part Number: A1084662A

Posted on Aug 26, 2007

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Standby light flashes 4 times

One option to try is to try to factory reset the tv, to do this turn the tv on hold the Down Arrow on the remote and while doing this press the power button then release the down arrow button.

Bit of info on your issue
* Four blinks - No vertical Deflection (V STOP), Screen goes to a single horizontal line then the video signal muted. Check IC1509, Q1505

Trend to find everything
0helpful
1answer

Red light blinks 3 times

I found this with a google search. I will put the link here to give credit to the site. This is not my own info. Full credit goes to the site owner.
  • 3 times, Diagnosis: +B overvoltage (OVP). Possible causes: IC501 is faulty (G board), IC5002 is faulty (G board). Symptoms of the problem: TV has entered standby mode.
http://www.somelifeblog.com/2007/08/sony-tv-led-blinking-codes-what-does-it.html
0helpful
1answer

Sony bravia kdl55hx729 3d led tv turns on 3 seconds shows picture than four red flashes

Hello,
the error light sequence that you are seeing is indicating a "backlight error". Most likely you have a bad inverter board -the board that powers up the back-lights behind the display panel. They might be available via ebay if you are a DIYer, or you need to call for sony service.
Good Luck!
Rich Lilja
3helpful
2answers

Tv will not turn on red standby light blinks 6 times

tv will not turn on red standby light blinks 6, on a sony grand wega kdf-55xs955 55 in. rear projection hdtv television
0helpful
2answers

Kdf55wf655 55 inch sony wega 6 blinking lred lights

For free sony support go the link choose the produce and chat for free
http://esupport.sony.com/US/perl/support-contacts.pl


Thanks for using fixya. Hope this solution may have helped you.
0helpful
1answer

Standby light blinks 6 times

It is fuse issue again. Go to this website and you should have solution or ask for one:
http://www.avsforum.com/avs-vb/showthread.php?t=507602
0helpful
2answers

Green standby/power light bilnks and pic goes out

you have defective power supply! at the hot side section!
0helpful
1answer

Tv will not turn on

4 blinks is a fan error. most of the time its th main fan on the back. blow the inde of the fan out with dust. if this dont work you will need to replace the fan
Not finding what you are looking for?

600 views

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76842 Answers

Ekse

Level 3 Expert

13435 Answers

Nasir Muhammad
Nasir Muhammad

Level 2 Expert

252 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...