White Screen Keypad works and phone is receiving/making calls. Inside screen is white, outside screen is blue. Neither with text. Solutions?

sounds like the membrane under the keypad is faulty, and it plays a major part in the cell, as it powers the screen, speaker and keypad. just see ur local motorola accredited service centre, and make sure they use genuine parts

nick

sir is it blinks with white screen only or blinks with white screen then shut down?
-if the phone can receive/send text and mms messages while the incoming and outgoing calls become shut down,i think you need to replace the battery because it is weak.use only original battery.
-and if it is blink with white screen only try to reset all settings or reformat your phone,if not work hardware problem go to repair shop.

take the phone and have the lcd replaced on the phone from a mobile service center

buy a new phone and try real hard nt to drop it the a920 tends to pack up when dropped as it happened to my last a920 and even telecom went to repair it but it was going to cost more than the price of a replacement a920

Does the phone still work? can you make calls? If so, yes, a screen replacement will work.

A white screen usually means no signal is being received by the screen. A black screen means the lcd back light probably died.

sidekick LCD screens

Same problem here...must be a bug with the phone or has to do with DST..Appears all E815's will not work.

have the LCD replaced and the phone full service take it to a mobile service center close to you.

this could be a firmware problem, though i have not known motorolas to have firmware problems.

you need to either replace the flexcable or have the service center reflash the keypad file.

Before you open it and look inside it check to see if the magnetic switch is stuck. Check it with a kitchen magnet to the upper righthand corner of the keypad. There is a magnet in the lower righthand corner to activate it. Do some of the function work when it is closed? If they do then it is not the cable but the switch. Does the outside screen look the same as if it is closed then it is this switch? Could be a bad one, something stuck in there, or it could be stuck.