Sharp Carousel will not turn on unless I lift gently on the door.

This appears to be an Australian model and these are the only spares I can find. They do sell the latches. If the hinges are damaged and causing this, you will feel movement. Looks like it is time for a new one.

https://spares.bigwarehouse.com.au/index.php?cPath=46427_53341_57047

https://www.google.com/search?q=sharp+R-9X56+replacement+hinges

..

check the door lever

Possibly a bad door switch behind the holes where the latch hooks go into. Usually with the bad switch the timer counts down but nothing runs. It all depends on which switch is bad. Usually 3 switches inside.

They is one of the DOOR SWITCH need to replace

There are door switches and one of them is evidently out of adjustment or the little actuator arm on it is.

Can you remove the timer panel?? Do you see screws to do that?? Make sure the unit is unplugged first. Then once inside check the door switches and the wires to them. Look for a switch that doesn't click when you push the plunger on the top. Or a browned wire terminal to the switch. That is where your problem will be.

I also have the Sharp Carosoul oven, symptoms - fan runs, controls are fine but the turntable stopped turning and it did not heat. It was not the switches, fuse, but in fact a sagging door that misaligned with the door switches. The true cause was a warn top hinge. As a temporary fix, I adjusted the bottom hinge (3 screws underneath), straightened the door, and now it works again.

This is usually caused by either a bad door switch or a loose door switch mount, which are pretty simple problems to fix.

Even though a door switch clicks, it may still be bad inside.

Door switch or mount trouble is usually caused by slamming the door or by opening the door while it's cooking without hitting the Stop pad first.

There are plastic mounts inside the microwave which hold the door switches and onto which the door latches lock when you close the door.

The screws on these mounts may be loose. If they get too loose, the switches will not be activated properly.

Sometimes it's a broken tab on the switch holder, allowing the switch to rotate just out of position. This tab can be hard to see, since it is under the bottom edge of the switch.

One test that sometimes helps is to gently lift up (and/or push down) on the door or handle as you try to start it. If it works or tries to work, then it's a door switch mount or door alignment issue.

If you or someone you know decide to look into it, we have critical information on safety, disassembly and door switches at our site, and our link is at our listing here on FixYa:.

If you only need a switch, you can order a universal type here for $5 postpaid.

Otherwise, the best place to order Sharp parts is Tritronics.

You can also call them at 866-779-5835.

If you think the problem is on the control panel, we repair these nationwide by mail for $39.95 postpaid in most cases.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Sounds like an intermittent door switch or a loose door switch mount. Very common.

At our site, we have critical safety information, info on door switch diagnosis and replacement, and disassembly information.

See our listing here on FixYa: http://tinyurl.com/yzjozk

One of your door interlock switches is defective . I would suggest having it repaired by a qualified repair tech in your area.