Kenmore 62602 Electric Dryer Logo

Related Topics:

Anonymous
Anonymous Posted on May 13, 2017
Be the first to answer

Reset 417 My dryer is beeping and the lights are blinking. I've thoroughly cleaned the lint trap and tried this previous suggestion: Unplug the machine for 30 minutes , plug it back it, start it for 1 minute, unplug it again for 5 minutes then plug back it and it should work. If not then write back with the error codes so further diagnostics can be done. The dryness indicator lights will not come on or adjust with the button but they come on blinking & beeping when the dryer is on. It stays on for one minute then cuts off.

Answer This Question

5 Related Answers

Anonymous

  • 12 Answers
  • Posted on Feb 28, 2008

SOURCE: Dryer stops after 5 minutes

dryer moter is covered with lint and over heating.if the moter is not completely burned out `you mite clean it with air pressure .if it still does it `replace it.

Ad

Anonymous

  • 525 Answers
  • Posted on Jun 22, 2008

SOURCE: KENMORE ELITE OASIS HE CANYON CAPACITY DRYER

Below is a link that will help you with parts and diagnostic procedures that are specifically tuned to your manufacturers data plate information. This model is manufactured by Whirlpool, so maybe you can locate your model's failure codes.
http://www.repairclinic.com/0078.asp

If my assistance helped resolve this issue, please show your appreciation by rating how effective my advice was in resolving this issue.
Thank you,
Dave E. (Illeagle)
"Your satisfaction is my personal reward"

Anonymous

  • 413 Answers
  • Posted on Jun 26, 2008

SOURCE: Dryer stays hot hours after using it

The heater has failed and/or is shorting to the case. Remove the rear panel. The heater is on the right side, attached to the heater housing with two screws.

Anonymous

  • 1 Answer
  • Posted on Nov 03, 2008

SOURCE: Kenmore Elite Elec Dryer Model # 110 62032100

Kenmore Ellite Dryer - Model 110.73952102 Type DDOT - NAT 1206006 - EH22

The Heat does not turn on! It spins and spins but no Heat? Any suggestions and how to fix intructions would be greatly appreciated. Thank you!

Anonymous

  • 1 Answer
  • Posted on Dec 31, 2008

SOURCE: Kenmore Elite Oasis Steam dryer

After just now calling the service center it seems that unplugging the machine for 30 seconds or so will reset the control panel. The F 40 code means the signal wasn't working in the machine and resetting it solved the problem. Kind of like when you have to unplug the computer sometimes.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

The light on my whirlpool duet dryer keeps blinking on all settings, won't start
push power button on push any cycle button hold down 3-5 seconds release push 4-5 times . if that don't fix it unplug for 30 min try that. let me know if it works might check lint trap also
Read full answer
Mar 18, 2013 • Dryers
0helpful
1answer

Model AE9433 won't heat, says clean lint filter
If every thing is clean you mite need to reset it, unplug it for few minutes.
Read full answer
Dec 16, 2012 • Dryers
2helpful
1answer

Whirlpool dryer ler7646eq1 will not heat
First the most obvious and you've most likely covered yourself look at the lint trap/if clogged clean thoroughly with vacuum cleaner pull out lint trap and **** up as far as deep as you can get some of the lint that you don't see and believe me there's a ton depending on your exhaust/vent type . Next go outside check the vent attached to the outside of home for clogs/lint buildup lastly here's a trick I've personally used SEVERAL TIMES on my old ge dryer if you have a LEAF BLOWER pull dryer out of the way and next go outside remove exhast vent usually 4 phippls screws going out next remove vent/trap outside go back inside and use the leaf blower to blow out all of the lint caught in the vent tube your be surprised how much was in there. HOPE this quick fix addresses your dryer issue if not its most likely the dryers thermostat they're fairly cheap online. Just trying to save you a buck friend. Have a good day Ryan in Minnesota
Read full answer
Oct 17, 2012 • Whirlpool Dryers
0helpful
2answers

Frigidaire electric dryer stops after 10 seconds. Help?
You will need to replace the thermistor. Here is a link to the part.
Read full answer
Aug 13, 2012 • Frigidaire GLEQ2152ES Electric Dryer
0helpful
1answer

My dryer won't work! The light works and the lint

Hi

I believe that everything else is fine rather it is the thermal fuse that is located inside the rear panel to the exhaust duct that is bad and should be replaced. If you want you can test this fuse for continuity and if it is bad then it should be replaced, as it cannot be reset. If the fuse is fine then it can be due to the control board that is bad and should be replaced. Hope this helps...please post back for further assistance.

Daniel

Read full answer
Aug 27, 2011 • Kenmore Dryers
0helpful
1answer

My dryer has worked GREAT...today lights blinking check filter..I thoroughly cleaned the lint filter and cleaned behind and IN lint fliter trap and it still is blinking and WILL NOT let me dry anything....
No there is only 1 filter,typically once a error code is display unlit its clered it wont clear itself.refer to your owners manual to see how to clear the code
Read full answer
Aug 06, 2011 • Dryers
0helpful
1answer

I have a GE front loading dryer model # DBVH512EF0WW. It's about 1 1/2 to 2 years old. It has worked perfectly up until this point. When we push the start button, it just beeps twice, but does not...
Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

;'';
;
'
Read full answer
Jun 13, 2011 • GE DCVH515GF Gas Dryer
0helpful
1answer

I have a Kenmore HE2 dryer that was working just fine. My husband stopped it in the middle of it's cycle to check on the clothes. He cleaned the lint trap and put back. When he closed the door and tried to...
you can unplug it for about 30 minutes, but I would venture to guess that the sensor which is located below the lint trap(if you look down the trap you will see to screws) is dirty and need to be cleaned, clean gently as not to break the sensor. Good Luck Tim
Read full answer
Feb 25, 2011 • Kenmore 85871 Electric Dryer
7helpful
4answers

Keep getting 3 beeps and the lights come on while its beeping.
Mine has been beeping incessantly as well. Turned out that even though I was cleaning the filter after each load, there was still a ball of lint the size of a tennis ball that was blocking the lint sensor. To fix, I removed the screws from the plastic piece that holds the lint trap and slid it out (it won't come out entirely.) Then I used the mini attachments for my vacuum to remove the lint from the bottom of that space. Once I did that, the dryer has been working flawlessly.
Read full answer
Mar 24, 2008 • Frigidaire FEQ1442ES Electric Dryer
2helpful
3answers

Dryer stops drying and lint error message...
try cleaning the vent line. if you have a flex vent line make sure it isn't kinked in any spot. make sure the outlet outside does not have a birds nest or anything blocking it
Read full answer
Nov 10, 2007 • Siemens WT79020EU Electric Dryer
Not finding what you are looking for?

View Most Popular

62602 Electric Dryer

  • Dryers

Related Question

The light on my whirlpool duet dryer keeps blinking on all settings, won't start

  • Dryers

131 views

Ask a Question

Usually answered in minutes!

Popular Questions

Kenmore electric dryer won't start. #63841

Kenmore 63942 Dryer

Kenmore Dryer Model 110

Kenmore 63942 Dryer

Kenmore HE4t Dryer - no heat

Kenmore Elite HE4 Electric Dryer

Dryer Runs, but NO Heat

Kenmore 63942 Dryer

SOMETHING stuck inside the dryer body - something like a coin... let me knwo

Kenmore Elite HE4 Electric Dryer

Top Kenmore Dryers Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Kenmore Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...