We can not get past the feeding stage it is the only part of the house we have access to.

2 or 3 stage compressors normally run at a constant speed
the stages are from different size pistons
1st stage is a large piston for low pressures that feed to a second smaller piston for higher pressures and for 3 stage to an even smaller piston to get really high pressures
for example 1st stage =100psi
2nd stage =1500psi
3rdstage =3000psi
your manual should explain the set pressure for the compressor if the compressor speeds up , that is a two speed unit

If a factory reset is required. Press and hold both Volume buttons and the Power button simultaneously; an Android logo with an exclamation mark should appear. Press both Volume buttons at the same time to open Recovery Mode and use the Volume Up and Volume Down buttons to navigate.

An external equalizer will not help this at all. The problem is likely within the amp (feeding the main speakers), the connections from the board to the amp, or the speakers themselves. In other words, the answer would be "NO." Best of luck!

Step 2 of the Power On sequence is to initialize the CPU which is found on the ECU board.
Find someone who is trained to replace the board.

Please see my tip at http://www.fixya.com/cars/r5929960-s_thermostat . These are generic instructions. Specific instructions from autozone.com for your car are pasted below. If you get stuck, please get back to me.

1. If equipped with an automatic transmission, remove the exhaust manifold.
2. Drain the cooling system.
3. Remove the thermostat housing to water pump feed pipe bolts.

Remove the thermostat housing to water pump feed pipe.

Fig. Remove the thermostat

Remove the thermostat.

To install:

1. Install the thermostat.

Install the thermostat housing to water pump feed pipe.

Fig. Install the thermostat housing to water pump feed pipe

1. Install the thermostat housing to water pump feed pipe bolt and tighten the thermostat housing to water pump feed pipe bolt to 89 lb inches (10 Nm).
2. If equipped with an automatic transmission, install the exhaust manifold.
3. Fill the cooling system.

I will assume you are referring to the 2 stages in the front of the machine. The spiral auger rakes are the first stage, they are designed to collect the snow and feed it to the impeller. The impeller is the 2nd stage and is to throw the snow up the chute. The lower rakes in the front do nopt throw snow only collect it.

The heatpump is your 1st. stage heat, when you have a call for heat it will bring on the outdoor unit.
When the first stage heat can't heat the house and the indoor temperature drops 2° or 3° then 2nd. stage heat will kick in and maintain the house temperature at about 2° or 3° below the temperature setting.
If you outdoor unit fails or goes into defrost then emergency heat will kick in and keep the house at 2nd stage temperature approximately 2° or 3° below thermostat setting.
If you have an outdoor thermostat or balance point setting on outdoor board, it will shut the outdoor unit off at a certain set outdoor temperature and the 2nd stage heat will be primary heat for the house.

sp1 has been corupted this is comon problem use your acer recovery disks and use the repair my computer option on vista and go back to a previous system backup which should be just before sp1 started to install hope this helps

What brand of laptop is it? If it is a password problem with a laptop BIOS you are possibly SOL. They have ATMEL chips that have to be hacked. That is not easy to do.

Need more info.

hi if you have a small blow lamp warm up the shaft and the blade it should after about 5 mins come off also tap it gently with a small hammer try that good luck