The vacuum just al of a sudden didn't turn on

try pressing the reset button ,this link is the manual and will explain about filter reset,
http://www.instructionsmanuals.com/u2/pdf/aspiradoras/Miele-S500-en.pdf

no betty, stupid bit of kit imo, no operating switch, just on/off at the switch, which heats the water up. i measured 500ml of water heated using my kettle, put the top on, switched on, and waited. first time the steam didn't come out of the nozzle, so i removed the end and cleaned the nozzle with water, blew down the end from the big end, and replaced it, steam came out. big grumble though, the steam coming out is not that warm, don't advise you to, but i directed against my fingers, it's only hot at the exit of the pointing bit, used it to try and clean floor tiles and grout, complete waste of time. i wouldn't advise anyone to buy one.

Good Aternoon lrmulholland,

Do you know what model Aqualisa shower you have or are you able to take a photo of it for us? That would be very useful.

Kind Regards,

The Aqualisa Team

It sounds like you have a faulty switch or a bad power cord those would be the first place to start troubleshooting

Upload your photo at the bottom of this window, where it says "Pictures".

Are you sure that something didn't get in the beater brush and is blocking it from turning?

Does the vacuum ****?

What was the last thing that happened when it started not working?

more details?

Best regards
Ck

I have an Oreck vacuum. My son used it just earlier today and it worked just fine, then just a little while ago a tried to turn it on to vacuum our bedroom and suddenly it won't turn on! I tried plugging it into other outlets but it was no use. My husband takes a look at it and first thinks that the switch is out in it. He takes the handle apart and quickly realizes that it is not the switch that is causing the problem. Then he took the base of the vacuum apart, removes the spin brush part and cleans it off, puts it back together, and suddenly it works! He said that when those brushes get real dirty the motor gets clogged, then it just won't turn on. I'm just happy I married someone who can figure these things out, because even if I knew the problem I'm still no good with a screwdriver, taking things apart and putting them back together again. Hope this works for your Oreck too and it's running again for you soon.

possible bad micro switch that turns on and off the beater bar the switch is located in the motor housing if u don't know what u r doing take too warranty repair shop

Either there is something wrong with your switch. Which it doesnt sound like it. Take it to your dealer or call another one it sounds like the control valve needs to be replaced. I am a dealer 1-866-966-9350.