Trouble shoot of power delay - Sanyo DS25320 TV

Likely the the fuel shutoff solenoid has stopped fuel but not necessarily the solenoid itself is at fault. You'll need to check the solenoid at the time of failure and determine if it has power. The relay is located on the injector pump. https://partscatalog.deere.com/jdrc/sidebyside/equipment/82900/referrer/navigation/pgId/92358081

The fuel solenoid may be commanded off by other safety switches/relays. It may take a fair amount of trouble shooting.

The unit has a seat delay relay that is notorious for failing or it could be other safety switch or relay.

I'm not sure of this exact model, but the seat delay relay is usually easily removed. Unhook all the relay connections and remove relay. Then you reconnect the harness wiring by color code and gender, less the power and ground connects that fed the relay. You can run without the relay....it's only there if you bounce out of the seat on rough ground.

try you tubing your washing machine for trouble shooting. or google your washing machine information for trouble shooting instructions.

The delay start button is stuck in.

You use Live view to get an accurate focus then turn live view off and then once 2 sec delay has been selected (this can be done before going into Live View) release the shutter.

I pressed heavy wash 3 times and then start to make it perform a field test. It tested fine, but it stuck at 61 minutes for an hour while I was testing auto clean. Another thread indicated that the controller cable interface was getting moist.

Hi,
You need to have them install a delay timer that keeps the power off for a minute or so before restarting the unit...
what happens is the when the power goes off the compressor starts to run backwards.. it will take a minute for it to come to a complete stop...if the power comes on before it has stopped and is still running backwards it will continue to run backwards...
You also can do the same thing by pulling the circuit breaker and waiting a minute and reapplying power...
however the delay is the best fix...

Here is a tip about trouble shooting your air conditioner...

Air Conditioner Trouble -Review the Possibilities
http://www.fixya.com/support/r3571569-air_conditioner_trouble_review_the_possi

heatman101

Select Custom Settings, then Self-Timer. You can set the time delay there.

Replace the thermal fuse inside the control panel.
Part #3376359

call whirlpool, sounds as if you have a faulty electronic control board( power supply board) warranty issue, non need for you to get involved with the repairing of this

upper right of camera back side is bracket with 3 dots [---], press and change to center point for accurate focus ... also in tripod shooting, you can set a delay (timer) for 2 seconds to make sure that the camera is still while shooting