System E 74 error

good day sir you can fix it on your own just visit this link for the instruction on how to fix system error 74 on your x box 360 console... if you think that this help you please rate me thank you sir....

http://support.microsoft.com/kb/907536

E74 is due to an inherent engineering flaw and will continue on new consoles until Microsoft institutes a revision.

E 74, E 79, E 71 is shown on screen and a solution to fix it is by ensuring that your A/V connections on your Xbox 360 is secured. Another possible cause to the error is that there is a power surge or outage on your system.

BETTER U Click here to download repair guide

Please let me know if you know the cause?

Your xbox is becomeing to hot you must check with xbox to see if you still can send it back to get it fixed.

hope this helps you out

EnVy

Microsoft offers warranties on 360's up to 3 years on e-74 error. They changed the policy about a year ago!

take your xbox rap it up in 3 or 4 layers and let it over heat itself it is like a really hard reset

First check your AV cable. Unplug it, put it back in, turn back on. If that doesn't work, long story short, call support (18004myxbox).

Error explanation below:

E-74 - There is high chance it's a scaler chip problem (the "ANA" or "HANA" chip near the AV cable connection) it can also be caused by a faulty AV cable so check that first. In some cases it is a problem with the GPU and may be repairable by doing the x-clamp replacement (error 102)

102 error - Error in the "Digital Backbone" (CPU/GPU/RAM), this is usually caused by a cold solder joint between the GPU and the mainboard.
There are two theories to fixing this one deals with the "X" clamps that hold down the chips. The other involves re-Heating the chips. DO NOT attempt either of these if your console is still under warranty. If your console is still under warranty return it to the store where it was purchased or call MS to have it replaced.

E73: General Hardware Error: Ethernet port... this error is caused by a problem with the Ethernet port.
Try restarting without the Ethernet cable plugged in.
Also: If you have an addon intercooler, you might try detaching this and trying again.

There are a few code 74's, and Konica has a bulletins on them.

DESCRIPTION: Code 74-0 from the E-mail alert system. SOLUTION ID: 154045
SOLUTION: CAUSE: Paper remains at finisher main tray paper exit opening.

DESCRIPTION: Code 74-1 from the E-mail alert system. SOLUTION ID: 154055
SOLUTION: CAUSE: Booklet tray is full.
SOLUTION: Remove the paper from bottom exit of the finisher.

DESCRIPTION: Code 74-4 from the E-mail alert system. SOLUTION ID: 154058
SOLUTION: CAUSE: Paper remains inside finisher.
SOLUTION: Please remove copies from the finisher.

DESCRIPTION: Code 74-5 from the E-mail alert system. SOLUTION ID: 154059
SOLUTION: CAUSE: Punch trash box is full.
SOLUTION: Trash basket of punching unit is full. Please empty trash basket.

DESCRIPTION: Code 74-6 from the E-mail alert system. SOLUTION ID: 154066
SOLUTION: CAUSE: Sub-tray (first tray) is full.
SOLUTION: Sub tray is full. Please remove paper.

I'm guessing it just means the finisher thinks it's full, and wants you to take the copies / prints out.

error code 74 is
74: AV cable Error - There is a problem with the AV cable, try using a different AV cable.

hope this solves your problem
Maxicube