Manual focus on atn 258

Here's the link and I'm sure you will get the solution of your problem
Ford Focus 2000 2007 Factory Workshop Service Manual

Square metres is a measure of area. Cubic metres and cubic yards is a measure of volume. There is no conversion between them without a third dimension.

Consider a storeroom that's 40.3 square metres in area. How much stuff can you store in it? Well, that depends on how high the ceiling is. If the ceiling is 2 metres high then the volume of the room is 80.6 cubic metres. If the ceiling is 3 metres high then the volume is 120.9 cubic metres.

One cubic metre is about 1.31 cubic yards.

Hello, Welcome to ATN Russian image intensifier tube. That right Russian. There is a good possiblity that Russian manufactured the hole binocular with ATN name and logo on it. Typically, this image tube are made to their standards and not to USA standards. There are a lot of countries in this world that manufacture night vision devises and there parts. I know that ATN didn't pay what you paid for this nice looking....yes, that what I said "nice looking" But that about all it is... You can send it back to ATN for repairs but it will new Russian parts to replace old Russian parts.

Now, check IR illuminate to see if it is working. This 1st gen Russian image tube are good up to 80-100 yards. I wish you all the luck. GB...stewbison

• 1 Understand the formula. Converting units of measurements always requires a specific formula. The procedure from yards to meters is X (yards) multiplied by "0.9144" meters.
  
• 2 Write your formula with the number of yards. Multiply by "0.9144." For example, 100 yards * 0.9144 =?.
  
• 3 Use a calculator. In the example above, 100 yards * 0.9144 =?, the answer is 91.44 meters.
  

Hope this answers all your questions
Please remember to Rate/vote for any solution that helps you out.
Thanks for using Fixya.

Yes, the camera does attempt to illuminate the area to allow autofocus, but the darker it is, the harder it is for autofocus to work. This is a problem even with high-end SLRs.
Usually the center focus point is the strongest and focusing works best when there is a strong vertical line.

There isn't a complete solution, but you there are a couple of work-arounds If you have a camera with manual focus, then use manual focus Point the center focus point on an edge, depress the shutter button 1/2 way to focus, then re-frame the picture.

Sorry, You probly disloged the micro plate in the image intensifier tube or brok it. Very thing in scope MK258 is manufactured in Russia. I have two or three of these Russian image tube, they are all generation 1 and cheap. About the only thing they use of scope shock is a thin rubber colar around the image tube. There is a good possibly it destroyed the image tube, sorry. stewbison

I am on face book Richard with a picture of one ugly dude.

3 volt lithium

Hi there,

Yes this does happen when cars are just sat there,

I can suggest spraying some WD40 on the pads for now, and then geting another car to try tow you a few metres just to ease you out, after you have them moving jack the care out, take the wheels of and sand away the rust.

After this i suggest taking it to the garage and getting new pads and disc's

Hope this helps

No more lights steady type: Aries 390 Paladin, light guide only focus.

1. Typical problem subjects for autofocus 1) Very low-contrast subjects 2) Overlapping nearby and distant objects 3) Very bright subjects in the center 4) Subjects moving very fast 5) Subjects through glass Focus on an object that is at the same distance as the desired subject, apply Focus Lock, and then recompose the picture. Or set the lens focus mode switch to (or), and focus manually. (Manual focus is only possible with cameras providing this feature.) 2. Attempting to take pictures out of the camera's shooting distance: When taking pictures out of the camera's shooting distance, the subject will be out of focus. The shooting distance differs from each camera model. Please check the specifications of your camera in the instruction manual to determine the shooting distance.