Philips Magnavox 51MP392H Rear Projection Television Logo

Related Topics:

Question about Philips Magnavox 51MP392H Rear Projection Television

1 Answer

51" Magnavox projection TV

Hi, we have a 51" Magnavox projection TV. It is almost 2 yrs old. The sound still works on it, but one day the screen just went blank and now there is no picture. Does anyone have any suggestions as to what may be the problem? Or has anyone else had this issue with theirs? THANKS

Posted by Anonymous on

  • 4 more comments 
  • cadge Nov 02, 2007

    picture and sound went away...can hear a chirp sound about once a second..

  • Anonymous Nov 22, 2007

    exactly the same problem as tonywhite's problem.

  • Anonymous Jan 02, 2008

    no power. Can't use remote nor manual botton.

  • scott4169 Feb 04, 2008

    tv went black all the sudden, still have sound

  • gxs01s Feb 12, 2008

    same thing. watching tv, walked away for a minute, came back black screen. Still has sound.

  • Anonymous Sep 18, 2008

    I have the same problem. What did they replace

×

1 Answer

Anonymous

Same with mine. Two things that they have to install and they need the whole tv there to fix it and run it for a week. Cost 500.00!!!

Posted on Sep 30, 2007

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My 42 in. 42HP66 Toshiba Plasma TV popped and screen went blank

One of your y driver almost go bad. For your future problem please visit my site athttp://billy-tech.blogspot.com/
0helpful
1answer

The t.v.just went blank while watching it.

Power boards are like time bombs. When it's time is up, it's up. Since it is 3 yrs old, I would buy a new tv. Most TV parts only last 3-5 years anyways. It did a good job.
0helpful
1answer

60" Rear Projection TV

sounds like a convergence chip problem...

here is my general post for the 51 inch you'll have to look at the link for the manual and check to see if you have the STK392-120 chips or somthing bigger in the 60"


51MP392H/17
you need 2 Convergence IC's STK392-120's (120's and 150's will work) of course order 2 of the same type I'm using replacement 150's they allow for a little higher heat and were cheaper ALSO you need to replace the 12 resistors with 6.8 ohm metal film resistors, make sure they are metal film! don’t skimp out here I did and then they blew and fried my IC's and I had to replace everything again!

Great reference link that I posted
pictures on, check out page 3
http://www.techlore.com/forum/thread/16736/Magnavox-51MP392H-17-51-quot--TV-has-double-vision/

Where I got my parts that worked:
Suburban Electronics
http://www.suburban-elect.com/
Manual Library you should find all you need here:
http://www.techlore.com/group/2/list_downloads



What you need:
(2) STK392-120 OR STK392-150 IC
chips
(12) 6.8 Ohm Metal Film resistors
set of star screw drivers
15 watt pencil solder pencil, DO NOT use a high watt iron you will fry the surface mounted item.
good leaded solder, and flux

0helpful
2answers

Magnavox 51" Rear Project Red Streaks

Sounds like the convergence IC's went south.  
0helpful
1answer

Sony KP-41S3U

Good Day;
On that model look for a small yellow cap, half the size of coin, dime. LOOK very closely and you will see a small burnt spot on the cap. The TV uses about 4 of them, they are 120/110 @ 2 kv. There are located in the high voltage circuit.
This the most common, it could be flyback or HV devider.
Good Luck and Day, big irish.
LET ME know.
0helpful
1answer

51" Magnavox projection TV

I had the a similar issue. My TV broke - no sound and no video but the power light was still on.

I gave up and called in a repair tech.

He fixed my TV in less than 30 minutes by replacing a bad IC chip. He informed me that this is a very common problem with the older Magnavox TV sets and that its typicaly the same chip that fails.

I spent over 300.00 for the repair. The parts cost less than 20.00.

To help others in the same boat I put together a how to guide and parts kit on www.magnavoxhelp.com .  I'm not sure if it will work for you but it may be worth a shot.
0helpful
2answers
0helpful
3answers

MAGNAVOX BIG SCREEN TV

Hi, I am having the same exact issue with mine. Although, it is only about 2 yrs old. We are still trying to find out what is wrong with it.
3helpful
3answers

Magnavox 51" TV Screen

take the broken piece to the hardware store and have a piece of plexiglass cut the same size. thats what we did and it worked really well.
Not finding what you are looking for?

270 views

Ask a Question

Usually answered in minutes!

Top Philips Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1259 Answers

Jaime Hernandez

Level 3 Expert

2351 Answers

Cindy Wells

Level 3 Expert

6650 Answers

Are you a Philips Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...