Sharp Aquos LC-37D64U Skips HDMI

Question edited for clarity and order, 'make model (what it is)'.

On the television remote you have to select the Source or Input. Each press will take you through the HDMI ports and all other signal inputs like co-ax. Your LA channel is likely via the co-ax indoor aerial.

Support Details LC-32D64U

Sharp Electronics https://www.sharpusa.com > Support
Owners Manual. LC-32D64U ' LC-37D64U Operation Manual. DownloadOpens in a New Window. FAQs. These are FAQs related to your product. My TV is not powering on.

Sharp LC-32D64U 32" 16:9 AQUOS HD 1080p LCD ...

B & H Photo Video https://www.bhphotovideo.com > ... > Televisions

The LC-32D64U 32" 16:9 AQUOS HD 1080p LCD Television is an ultra-slim and light LCD TV, that easily enhances the decor of any media room.

..

are the cables ok?

This set MAY require or have available a software upgrade for this issue.

Contact Sharp to see if they have it or if this is an issue in their database that is common.

Input Channel 3 on your TV remote or maybe 003.

Your PS3 set itself above the max resolution your LC-C3237U. Most likely the PS3 is doing 1080P, but the highest the Sharp can do is 1080i. So do this:

1. Connect PS3 to TV (you can use the current cable or analog cable)
2. Turn on TV and set input to port PS3 is on.
3. Make sure PS3 is connected via correct cable.
4. Power on PS3 via power button and HOLD IT for 5 seconds (release after the second beep). It should automatically configure your PS3 to the TV's native resolution for all settings.

I’m happy to assist further over the phone at https://www.6ya.com/expert/kevin_c38b47f462e94458

You have it hooked up right. I found something on page 26 of your manual. Look at the HDMI setup section. I think that maybe the problem there. It's an audio select option for input 5.
Let me know if it works.

Good Day, Jamievass;
Please disconnect the NEW DVD Player, does analog stations come back? What input are you using; RF, Comp, hdmi? If ok try using another input or you may need a main bord that processes the signal.

Good Luck, big IRISH.

Digital inputs on Aquos TV's are "always on," usually the HDMI inputs and DVI inputs. As opposed to analog inputs 1, 2, or 3, are only activated once something is plugged in.
Try plugging in another HDMI sources into input4 or 5, if its still not working, the TV needs a new Main Board. Try calling Sharp 1-800-237-4277 and locating a local service center in your area.

If your using a HD converter box, there is usually a blink when switching from an HD channel to a non HD channel. It is just adjusting from different pictures modes such as changing from a 480i channel/show to a 1080i channel. If this is the case, its perfectly normal.

Change your input source. You are probably on Input Source "TV". My HDMI cable is plugged in INPUT 4 so make sure that your TV is set to the right INPUT.