Axy1059 Hi, I've heard the AXX1064 is the equivalent part to the AXY1059. Is that true?

http://www.alibaba.com/
Try this link to buy it online.
Gopakumar Gopalan Google

flatware is cutlery. it's a term used in the US. if youre shopping online for cutlery and its an american store, you have to look for it under flatware.

it is called your pcv

Absolutely, in a humid environment, over 75 percent of fleas can live without a host for 2 months. In cool, dry environment, only 10 percent will manage to survive. Humidity is the key to flea survival therefore lowering the humidity environment severely will cause flea to die or run away.

I do not think it is welded, Check out this online PDF on how to do your clutch. Clutch Help PDF1 Clutch Help PDF2 Then, it is for a 1995 but here is a video. Video Hope this helps FixYa up.

Don't believe all that you read. I've seen stuff posted on some of these forums that are way on the rediculous side. If you have concerns, call Harley's Customer Service department and ask if there was a recall on anything on your bike. Have the full frame VIN number handy. I haven't heard anything about the inner primary mainshaft bearing failing or anything about a recall on that part. Usually, if you have a problem in that area, its the seal starts leaking but that's due to normal wear but I've seen bikes with 75,000 miles on them with no leaks, no bearing failures. That's basically "luck of the draw". If there is a recall on anything on the bike, and a search of the VIN number does not show that the service has already been done, Harley will pay for it. If there is no recall, Harley will NOT pay for it.

Good Luck
Steve

Hello carolinemacl,

I'd imagine a gel would not help a controller at all to connect to a console. I've heard of Silica Gel Packs to help soak up moisture from the controller, that is if it got wet, and circuits shortening. Infrared remotes (I don't know if Xbox is an IR remote,) use infrared rays to send and receive messages. Infrared rays will transmit a gel filter. It's a hard question to answer.

If you have any other questions or concerns, feel free to contact me.

MOST manufacturers will, yes. But, your best bet is to contact the manufacturer directly and find out... try here:
http://storkcraftdirect.com/
http://storkcraftdirect.com/safety/keeping-babies-safe-for-over-60-years/

This is a little late (understatement), but the power supply for these third gen Pioneers, the AXX1064, is also sold as the HITACHI TS04071. Which can be bought for about half the price ($175 vs 334). They are the exact same part they just carry a different SKU/part number. Hitachi used to sell re-badged Pioneers as their own. They usually even come in the packaging. They can be bought from encompassparts.com or partstore.com.

I'm working the same problem. Q127 shorted, R217 & R 133 open. Also have solder blown off one end of R222 and R351 (both sm 200 ohm). Looks like small, short trace evaporated on top layer between D145 and via directly below it. Q129 is open all ways (but not exploded).
This one has C164 installed as 1200 uf, 10V.

Any success getting your going again?