Phone does not work properly

try loggin in and out then in #1
try removing app and reinstall #2
try a hard reset where you press and hold both the on/off button and home button at the same time till you see the apple logo #3

Yes, Agree with the comment above about the date and time. My computer continually did that for every site. the date was set right month and day but was set at 2011. as soon as i put in right date and year everything was fine.

dropped or banged it and broke the LCD and speaker by the description of the fault.

Hello. Well dropping your phone in water is likely to have caused that issue. The only thing i can suggest is that you make sure you have your phone drivers properly installed to you pc. If you have try uninstalling and reinstalling them. If that doesnt work as well i think you should refer to some experts. Hope i helped. Cheers

The crown wheel (winder) should have 3 positions, (1) the normal winding position (3) fully out; at this position the watch stops and the time can be adjusted.

(2) This position is between the 1 & 2 and is used to adjust the day and date. If you wish to change the date by winding the crown backwards or forwards.

Since watches can very a little, if turning the crown when in position 2 the date does not change, pull the crown to position 3 and turn the hands until you pass the midnight position, when the date will change and then re-set the time. If you wish to advance the time more than one day, when it changes, wind the crown backwards past the midnight position and then wind it forwards again. Repeat until the correct date is showing and then re-set the time. The exact distance you need to turn the crown to change the date will have to be found by experimenting!

most likely no

I could tell the base unit was about to go a few days ago. Have had the phone for years with intermittent problems but it has been for quite awhile now. However, the screen on the unit started to blink a bit a few days ago. Had a feeling it was about to go but the phone kept working until this morning when it suddenly dies. After reading that changeing the cord might work, I replace the unit power cord with one from my handset and the phone is working again! Thanks for the suggestion!

Did it get dropped when the camera was open? If so it could have made the lens pop out more on one side. I'm not sure how to really explain it. When you open the camera, the thing that comes out might be off track I guess you could say. What setting are you using it on?

the first step for put the used my

frigerator

There was another series of messages about this one...it happened to my prada as well. Go into the Settings > Date and Time > Auto Update....

Set Auto Update to ON

Power down the phone....(Cancel phone call button for 3-4 seconds)

Boot it back up (make phone call button for 3-4 seconds)

Problem should be resolved! Just did this to mine about 5 minutes ago, so not sure if it works, but others have said it does.

*Shakes fist at Prada* :P

ps...gorgeous phone tho...hehe...and very popular with the ladies ;P