How do i turn off the satellite - Motorola Mobility Karma QA1 Cell Phone

try this first

a. turn over computer overnight and let it 'drip dry'

b. take a hair dryer on low heat and fan and GENTLY run it over the keyboard about 1 inch back and at angle

try that first and report back

you might get lucky

Hi
Try replacing the battery.
Also check whether it charges,could be a faulty charger too.

The problem could be your display. Use the VGA port on the side of your laptop to connect it to a computer monitor, this will let you know if your system is posting or not. (If you see the Boot Screen it is posting).

Look on the back of your TV find out what input your satellite is plugged into ...right it down. On your remote find the Input buttom and select the same one as your inputs from your Satellite. turn off the TV and the satellite receiver...Wait 30 seconds. Turn the satellite receiver back on..wait 2 minutes...turn the TV back on.

turned of satellite,waited turned back on ok

Hi,
use the web-updater at garmin
or update the firmware at garmin,
turn WAAS on

turn GPS signal off
go outside after the update
turn GPS signal back on ( takes upto 15 mins to locate satelites )

should be good

Regards
Richard.

here is a website that will tell you the beeps and give an explination http://www.computerhope.com/beep.htm

Have you tried contacting your dish people, maybe they can reset.

Are you outside with a clear view of the sky? It should find satellites once the unit is turned on. Does it say "Looking for satellites" or "Acquiring satellites"?

If it is "looking for satellites" then it means that the unit have lost all data (time, date, location). If it is "acquiring satellites" then it have date and time, but not location.

Looking for satellites require a longer setup time (could be as much as 15 minutes). Acquiring satellites is much faster (not more than 2 minutes).

Date and time is updated from satellites once the unit gets a satellite lock.

Do you Have the right adapter Plugged in??