Sony XL-2100U Projector Lamp for KF-42WE610, KF-50WE610, KF-60WE610, KDF-60XBR950, KDF-70XBR95 Logo

Question about Sony XL-2100U Projector Lamp for KF-42WE610, KF-50WE610, KF-60WE610, KDF-60XBR950, KDF-70XBR95

2 Answers

Won't piwer on

Today I tried to turn it on my KF50WE610 that i have had for about 4 years, and the green power light blinked for about a minute, then the red Lamp light blinked for about another minute, then the red stand by light came on. Does this mead i need to replace a lamp or bulb?

Posted by ecarver on

  • 1 more comment 
  • TRIM Nov 07, 2007

    WHERE DOES BULB GO

  • EXFFPM Nov 27, 2007

    Sony KF-50WE610....lamp failed (red light blinking three times) for the fourth time since I bought the T.V. in 2004. Each time replacement bulb was Philips #312243871310. Had I been informed that I would incur a $300 cost annually on top of the $3000+ initial cost, I doubt I would have purchased this T.V. After reading the endless posts in the online forums regarding the greater problems with the "power block/light engine", I am terrified to turn it on once/if the lamp replacement is successful. Is this lamp failure inherent in every Sony LCD and is there something we can do to lessen these failures? Thank you!

  • Brianc7202 Jan 08, 2008

    I have the KF50WE610 and it is 3 years old, it wont turn on, but for the last year the TV would make a buzz sound and the the power light flashes and then it would either tuen on or if it made the sound again it would not turn on. If I tried it a couple of times it always eventually worked now the other day after an hour it turned on, It has to be something beside the lamp. Also how easy should th efront panel come off.

×

Ad

2 Answers

Anonymous

I pulled the manual, on page 13 it indicates if the red lamp light blinks, need to change the lamp light...it lasted almost a year with the ocassional slow start of lamp light blinking (perhaps 4-6 times), but the picture always came on within a couple of minutes, but now, picture will not come on....TV is about 4 yrs old also, exact same one you have....

Posted on Oct 03, 2007

Ad

Anonymous

Tried to turn it on? Sounds like you need to replace the lamp. However, I got an additional week out of my unit. Although poorly dimmed and the red Lamp light blinked constantly for that one week, at least it gave me enough warning to seek out a replacement. But so long as you're not mistaking the Power/Standby or Timer light for the Lamp light then I would have to agree with you. http://store.l-f-l.com/prod/A-1606-034-B Includes shipping to the United States and no sales tax outside of California.

Posted on Aug 22, 2007

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

Green timer light won't stop flashing on mitsubishi ws 73711.

the green light blinking is normal if set has been unplugged--when set is plugged back it should blink for about 70 seconds and then go out--then you can try to turn it on---it is the DM unit inside the set booting up.

If the light just blinks and never stops you have likely bad caps in the DM unit---there are kits available for that.

The other possible reason is that so called reset switch may be bad--fairly easy way to find that out and it is more common than you would think, let me know if you have questions.

SD TECH
0helpful
1answer

Replaced lamp but lamp light still blinks orange

I have a wd-57731 The lamp light blinked orange. i replaced the lamp turned the tv on and the timer blinks green for one minute and then the lamp light blinks orange again. It won't turn on. Can you suggest anything?
1helpful
1answer

My Mitsubishi Medallion tv stays on for about 10 minutes and then shuts down and won't turn back on until a period of time has passed. It is a rear projection tv about 9 years old. Can anyone help ex

When it shuts off and the green power light goes off, press both the menu and input buttons on the front of the set (not the remote) and hold both for about five seconds and release.

Power light will blink a two digit error code like 2 blinks and then 3 blinks and repeat it several times.

What is the error code?
1helpful
1answer

Fisher Paykel DS605i single dishdrawer with a user-supplied integrate panel. There are three buttons on front. The left-hand button is power button; the center button is start/pause; and the right-hand...

Hello, Thank You for using FixYa. I will be helping you today.Are any of the cycle lights lighting up like rinse and normal and is the light on front blinking and pausing if so how many times is it blinking? Try turning the power off too the unit for five minutes and back on, because if the lid was open some or was stuck it can stop the unit from running.
Thank You and please ACCEPT my answer and Rate my answer if it was helpful..
0helpful
1answer

Red light blinks

Check the lamp door (with green on) ,.. both green and red blink - bad lamp. Green off, red blinks..Try unpluging for 2 minutes and retry - if no different (sorry, call a service person).
Not finding what you are looking for?

1,213 views

Ask a Question

Usually answered in minutes!

Top Sony Office Equipment & Supplies Experts

The Knight
The Knight

Level 3 Expert

76835 Answers

Ekse

Level 3 Expert

13435 Answers

AAA TV Service
AAA TV Service

Level 2 Expert

272 Answers

Are you a Sony Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...