My washer dryer will not dry clothes, i am assuming the water is hot to wash the clothes as it reaches the end of the cycle fine (am told if water was not heating it would not rinse or finish cycle)am unsure of whether there is a reset button inside machine or how to clean out a filter, any help would be much appreciated
Click on your model number above, (below FIXYA) on this site, & search. You will get a shortlist; click on your model, below the page u will get Manual/Guides. Click on the blue, you have your manual on line.
And dont forget to rate me on this great site.
Posted on Jan 26, 2008
Jul 25, 2017 | Frigidaire Washing Machines
Mar 25, 2017 | LG TROMM WM2688H 4.0 cu.ft. Front Loading...
Dec 15, 2009 | Kenmore Dishwashers
Aug 09, 2009 | LG TROMM WM2688H 4.0 cu.ft. Front Loading...
Feb 16, 2009 | Frigidaire FTF2140F Front Load Washer
Feb 03, 2009 | Bosch Logixx WFT 2806 Front Load...
Oct 31, 2008 | Haier XQG50-11 Front Load Washer / Dryer
Oct 24, 2008 | Washing Machines
Jan 25, 2008 | Equator EZ 3710 Front Load Washer / Dryer
Jun 03, 2007 | Zanussi ZWD1270 Front Load Washer / Dryer
Apr 26, 2014 | Hoover AL130 Front Load Washer
Sep 27, 2011 | Hoover AL130 Front Load Washer
Nov 08, 2017 | Hoover AL130 Front Load Washer
2,756 views
Usually answered in minutes!
Hi the inlet tube that takes the water and the soap poweder to the washing machine drum is blocked, and causes the water and powder to overflow and leak from the powder draw? any advise? or any suggestions where I can find a service manual for my hoover six express 1300 (WDM 130) ?
on a 6 year old WDM130 - some rather bizarre things happen. It will go through the full wash cycle with no problems- sometimes. At other times it reaches the end of the cycle but hasn't rinsed properly or spun, so washing v.wet and not clean. But I can get by this by...
pushing the on-off button on the front on and off about 8 times halfway through the wash cycle. This seems to get the cycle back on track again and it will complete. Also, if it dosesnt spin, I can re-set the proagramme dial to the spin setting, and start the machine with the door OPEN - and it starts! But it won't do this at the start of the programme.
What have I done? - looked at it, cleaned out all the pipes, hoses to make sure not blocked. And looked at a new machine. Problem is I'm tight, and also this machine was under an extended warranty and had a new door, drum, motor, programmer, timer, relay, tray, etc. over the course of the 5 year period. And its performance (when it does a full cycle) is excellent - still. Is there any way of unpicking what is wrong with it, or is it a service engineer call out? Also, I'm intrigued. How can switching it on and off lots of times make a difference, but it does?
×