Operation light red - Toshiba 57H83 TV

Contact the maker or distributor as it has failed and you need a new part.

Flashing red light.
Oxidizing Module has failed.
Contact your distributor or GreenTech Environmental for replacement.


The Indicator Light, viewed through the horizontal window on the front of your pureWash has two states of operation . Blue Light - Indicates normal operation of pureWash . Red Light - Indicates the fan or oxidizer generator is not operating properly .

Owner's Manual

Abt https://content.abt.com > documents > PUREWAS...
..

http://www.ehomeservices.com.sg/articles/how-to-solve-air-conditioner-light-blinking-problem.html

If you see the red flashing light during regular operation, this usually means that the outdoor unit was shut off due to a problem and is currently "locked out" from normal operation. When you see the red flashing light, it is usually in a diagnostic feature to alert the HVAC repair technician to what the problem is.
https://www.onehourheatandair.com/bay-area/about-us/blog/2016/may/what-does-a-thermostat-red-blinking-light-mean-/

Red light should go out when freezer reaches operating temperature

• Solid Blue - Normal operation, "Touch" mode is activated.
• Flashing Blue - Normal operation, the hands-free mode is activated.
• Solid Red - Warning mode - Replace batteries as soon as possible. While the water is running Solid Red LED is illuminated. When the water is off, the Red LED flashes once every 5 seconds. The faucet operates normally, solenoid valve is open.
• Rapid Flash Red - Alert Mode - Battery Failure Imminent. The Red LED flashes once a second. The first time the faucet is used, the Red LED will turn ON, the solenoid valve will be opened and remain open. The manual valve must be used until the batteries are replaced.
• Solid Red - Lockdown Mode - Replace Batteries. Extremely Low Batteries - The RED LED is ON, and water will not flow. The solenoid valve is closed and faucet will not operate until batteries are replaced.
• Long Flash Red (2 seconds on / 2 seconds off) - Board error, replace electronics kit, RP53230 See manual bypass of electronics section of Installation instructions.

THAT FLASHING RED LIGHT IS PROBABLY THE RECIEVER FOR YOUR REMOTE CONTROL & EITHER IT'S SIGNALING PROPER OPERATION, OR YOUR BATTERIES AT FIREPLACE RECIEVER ARE LOW, & SOON THE REMOTE WILL NOT OPERATE IT AT ALL. CHECK THE BATTERIES!

it could be jammed

check that it is set to cooling sounds like it may be set to heat in cooling mode the indoor fan should at least run

not knowing wich one is on, this red light could be your power indicator light..
it stays on during any operation,
you should be able to see it through the sight glass
if it were flashing,,,, there would be a problem

Hey habo,

The red light you are referring to most likely is the power indicator light. On many newer TV's this light will appear red when the TV is off or in "standby" mode, and green when the TV is in operation.

Please keep in mind that some TV models may use the power indicator light to notify owners of ay potential hardware problems as well, so you may wish to refer to your owner's manual documentation if you have been encountering any problems during TV operation.

Hope this helps you out.

Sincerely,
Aaron
Go Ahead. Use Us.