Polycom 7000 series System Settings

You can use the hardware restore button on the Polycom HDX system to reset
the system in one of these ways:
• Restoring configuration-Restores the configuration, which resets most
system settings to default values.

• Factory restore-Completely erases the system and restores it to the
software version and default configuration stored in its factory partition.
If you follow this procedure while a USB storage device is connected, the
system restores from the USB device instead of the system's factory
partition.
The restore button is on the front of the Polycom HDX 9000 series system, as
shown in the following figure.





The restore button is on the front of the Polycom HDX 8000 series, Polycom
HDX 7000 series, and Polycom HDX 4000 systems, as shown in the following
figure.




The restore button is on the left side of the Polycom HDX 4500 system, behind
a wire mesh screen, as shown in the following figure.





Use a paperclip to press the restore button through the wire mesh covering
that side of the system. to reset the HDX Series system we can press the restore button over 15 second.

Thank you

The factory Admin info is Polycom for the user and 456 for the password. If the password has been changed, you can do a factory reset by holding down 4 keys until it restarts. The four keys are * 4 6 8.

You need to go into the audio settings via
Admin Settings
Audio Settings
and make sure Enable Polycom Microphone is checked off.
Reboot and see if your microphone is recognized.

Verify the uplink / download bandwidthon the broadband link.Broadband link do not have symmetrical upstream/downstream speeds. Perform test to verify.
Try non-peak hrs.
Check if latency is consistent.

Hopefully the problem was resolved. Call Polycom to see if it under warranty. Call me at 415.659-8178 if it is not. Maybe I can help. David

The polycom didn't allow for numbers, only letters.....
How do I do password recovery in this case?

The default is Admin with password of the 14-digit serial number

put a paperclip in the front just below power button and turn unit on. this will factory reset it.

I've just solved that problem in the VSX 7000 of my girlfriend's Job.

Your VSX7000 has at least 4 video outputs, 1 for VGA and Supervideo 1 and Supervideo 2.

Firstly you should try VGA connector, because the main menu may be there, so you could change the configuracion.

If you can't see main screen in any of the output connectors you'll have to use the http tool.

In your internet browser enter the camera IP address, and you'll get the Web Interface of the VSX7000.

It will prompt you for user & password, the default options are "Admin" and your VSX7000 serial number (14 digits) you can find this number under the camera.

Once you're in the Web Main Menu, click on Site Map. There you can choose what you want to see in the screen of Monitor1 (My menus are in Spanish, maybe your menu says something like "screens" but I'm sure you'll find it)

If you choose Monitor/Screen 1 as Svideo, and select it as output for Local, Remote and Content you should see the Main Menu after the VSX7000 Reboots.

I hope it would be useful for you, if you have any problem with this let me know... This VSX7000 is working fine now, so yours should work!