Cant get the old blade off

Take a look on amazon for sure. Amazon com Husky tile saw. If cant find just a motor, for sure there is someone to answer that question (someone who sells husky saws...). I hope this was helpful. cheers

where can I buy a new pan 28x181/2 for my husky wet tile cutter

Hi, Take a look at amazon for replacement parts: Amazon com Husky tile saw. Hope this was helpful. cheers

You can get the part from husky website at:

http://www.huskysupport.com/products/product.aspx?ID=4

From there scroll down till you see part number
6102018
switch Knob for $5.38

Hope this is what you are looking for

I am a contractor who has used this saw for about four years. I just ordered the new motor for $79. The Husky has been a great saw. Don't waste your money buying some junk for Harbor Freight.

I need to replace the ball bearings in my Husky THD950L tile saw. Please tell me where I can find them.

Make sure both sides of blade are wet. Make sure blade is not worn out. Do not feed the tile excessively fast.

Next, and very important is that the blade arbor is at true to the table. If the saw is slanted in the least, the saw will track off course. I am talking VERTICAL slant.

Verify that the arbor bearings are tight and there is no "end shake"

With the saw UNPLUGGED, check around the base of the motor shaft, there should be some kind of button that you can depress to lock the blade from turning. Then with the appropriate sized wrench, turn the blade locking bolt clockwise (it is a backward thread) to loosen it. Then simply remove the washers, etc carefully and replace them the same way they came off. If there is no locking button, you can use a scrap piece of wood on the saw table and push down on the blade to lock it in place.

i know blades on tile saws don't have to be super tight, i'm not familar with that kind of saw, i put a wrench on the nut and hold on to the blade with my hand and hit the wrench with a rubber mallet, and of course have the unit unplugged

should have blade lock button remove blade with proper size wrench reinstall new blade in reverse remember some of these the loosening of the blade will be clockwise so if nut dont come loose try clockwise to loosen good luck