When device is boots up an error displays on the main screen stating:
'Malfuction detected. Please call your technical representative.'
TEL
FAX
C-3851
This is the error exactly. Any help would be greatly appreciated.
Regards,
Joe Arpaio
First power off the printer completely. Then power it back on while holding the UTILITY/COUNTER button. You will see the minolta logo, then you will see a troubleshoot reset button. Press it, you will see an OK result. Power off the printer again, then power it back on without holding the button and everything should work.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
C - 2651 Cyan imaging unit EEPROM acces error C - 2652 Magenta imaging unit EEPROM acces error C - 2653 Yellow imaging unit EEPROM acces error C - 2654 Black imaging unit EEPROM acces error. Clean the connection between the imaging unit and the machine if dirty.Reinstall imaging unit or change imaging unit. Try reset: Turn OFF the copier. Press and keep pressed the Utility key and turn ON the copier. Keep pressed the Utility key when the Trouble resest message is displayed. Release the Utility key and touch the message and turn OFF the copier.Wait 1 minutes and turn ON.
enter service mode, select state confirmation, select memory/hdd adj, select hdd format, select physical format, press start button, when displays ok turn off main power for 10 seconds, c-d010 will display again, repeat instructions and do logical format, turn main power off for 10 seconds..should be ok si
Try resetting. To reset a Rank A error follow these steps:
1. Turn OFF the Main Power Switch. 2. Turn Main Power Switch ON while pressing the Utility/Counter key. 3. Touch [Trouble Reset]. 4. Check to make sure that [OK] is displayed and the it has been reset. 5. After turning off the Main Power Switch, turn it on again more than 10 seconds after and check if the machine starts correctly.
If the error recurrs then do the following:
1 Check the Fusing Unit for correct installation (whether it is secured in position). 2 Check the Fusing Unit, PWB-M and PU1 for proper connection and correct or change as necessary. 3 Change Fusing Unit 4 Change PWB-M 5 Change PU1
×