HOW DO YOU GET REMOTE TO RESPOND TO COMMANDS

JUST UPDATE WITH LATEST FIRMWARE

Hello,

error 345 while faxing is related to Communication error. This error is not related to printer hardware issue.
Below are the possibilities ....

1. The remote machine failed to respond to a fax command from the local machine because the connection was interrupted.
2. The remote machine failed to respond to a fax command from the local machine because the connection was interrupted.
3. The remote user pressed the Stop key while the reception was in progress.
   
   The suggested solution would be as follows....

• Retryt the fax reception at a different time when telephone line conditions have improved. Call the telephone provider if line conditions fail to improve.
• Disable ECM. Errors might still occur, and might result in a degraded image quality on the received page. However, the ability to send the entire document will be improved.
• Try sending at a lower transmission speed.

Does the device not respond at all?

You can try learning the commands from the original remote to ensure that they are correct.

1. In the software, click 'Learn IR' next to the icon for the device. 2. Go through the list of commands and learn the ones you think you will need by clicking 'Learn'.

The important commands of course are the power commands and input commands. Also channel and volume commands.

Hope that helps :)

I returned it to LG. Thanks for your help.

I'm sure you've tried this, remote batteries is most common cause.
Make sure sensors on TV and remote are unobstructed(remote only works if line of sight to sensor is clear) and clean. Windex and Qtip. Damaged/dirty/defective remote, try different if possible (universal). If none of above works(99% chance), extreme longshot is TV circuitry.

hello,good day,first try to use your spare key,or check your fuse box at the rear,near your battery,if not corrected,send your car to a dealer for proper diagnose by using hht or star,ty

Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed . you can go there and try free

from the book: this is for the HRMC-5 may be the same.
Code Scan if you don't know the code.

Keep remote aimed at the device you want to control. during the programing, the device will send out a "power" command for the device being programmed.

While holding down the device key(i.e., TV) that you are programming, press the "Mute key for one full second. then release the keys. the device key should light up and stay lit. if not, repeat the process.

repeatidly tap the channel up key to step through the codes, sending out the "power command". may take some time, many codes. when device shuts off, you have found the code. If you inadvertantly went past the code, that responded, you can press the channel down key to go back. press the "power key to verify you havent missed the code. In order to lock in the code, press the device key again. the remote will remember the code till you re program it.

the tv wont come on the standy timer light is on

Try blowing into the controllers plug and then blow into the slot in the ps2