I have this receiver in the garage, with some power outages Ihave had I can't get it to turn on. I do not have the remote for it either. I got it to work one day, don't know what I did though....pushed a lot of buttons. Since then it will not even turn on....Any Ideas???
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
MY first power outage-restart blew out two clocks and the doorbell. After a lengthy chat with the power folks they replaced both clocks and got me a new doorbell unit. They have a process for restoring power which does NOT blow up consumer's stuff
www.liftmaster.com/.../en.../tucmanuals/114A3044.pdf
Chamberlain GroupThe Chamberlain Group, Inc. 845 Larch Avenue. Elmhurst ... Please read this manualand the enclosed safety materials carefully! ? Fasten the manual near the ...
The remote might not work if the memory was lost during the outage. However the switch on the wall should work because it is hard wired to the motor. Reprogramming may be in order.
sounds like a power outage at some point. check batteries in remotes. re-program remotes to motor. get ladder, push square button on rear of motor then press button on remote. press remote again to check operation. repeat for second remote.
Along with the power outage you probably also had a power surge. You need to pull the logic board and check the printed circuit board for burnt or missing traces. Unplug the unit first.
Hi,
Since the Harmony remote has no way of being affected by a power outage, I would say that this is more an issue with your receiver itself. There was probably a power surge, and the IR receiver may have been damaged. I would try the original remote, or call the manufacturer to see if there is any way to reset the receiver.
You will need to get a surge protector on this unit first of all. You will have to replace the logic board and maybe the wall button or sensors depending on how bad the surge was. Any time the power goes out the logic board can be affected by it. Thanks BB
×