Sony SNC-P1 How i can restart my cam, i miss my admin and password?

if it is a 3 volt battery then anything less than 2.9 indicates a flat battery

here is the link to the user manual if you need it; http://bssc.sel.sony.com/BroadcastandBusiness/docs/manuals/snc-rz30nuserguidev2.0.pdf or http://bssc.sel.sony.com/BroadcastandBusiness/docs/manuals/usesguidesncrz30nv4.pdf check page 25 (top left) for reset to default instructions (you have to read back a couple of pages to find the menu they are talking about) - there is however no mention of any password issues when you do this. If you do need the password to carry out the reset procedure, then I think you need to contact Sony - the camera is expensive enough that they should help; http://bssc.sel.sony.com/BroadcastandBusiness/info/contact.shtml Hope this helps:)

hold reset pin while you plug in the camera and wait till network light turns orange before letting go then the default pw and user are admin/admin

Driver is available on website other then Sony Support so download it at your own risk. Make sure Anti-Virus software is installed and updated in your computer.

Click HERE to download driver for Sony SNC-P1 camera.

Sam, Go to http://www.howtodrivers.com/model565630.html
and download the driver for your device.

in the rear camera have the reset, turn off the camera and turn on the camera and holding the reset button.

sony tech: [email protected]

turn on the camera and holding the reset button and try again.

how can i find my ip address on my snc-rz30n network camera

this may help you http://www.milestonesys.com/Downloads

yuirtyrtyrtyrtyrtyrty