How do i bypass the brake safety switch on a pionner avh-p4000

there is a light green wire that needs to go to the parking brake. video will not work unless the parking brake is on. this is for safety reasons and it is illegal for the driver to view videos while driving.

ground out the park brake wire

the green wire is the e brake cable if you ground this wire you can bypass the need for the e brake keep in mind that because of the type of deck you have you will need to install a switch and you will have to switch ths on and off everytime you turn into or awayfrom acc

better check on your dc wiring system make sure u have fixed them tightly

sorry i have attemptede this 3 times.
Facebook send login info to the last registered email address. You should ask for a reset option

Try visiting this site:
http://cgi.ebay.ca/Pioneer-AVH-P5700-video-bypass-Module-DVD-kit-new-P5700_W0QQitemZ230333866203QQcmdZViewItemQQimsxZ20090329?IMSfp=TL090329135001r4617

ground the wire to a hot (ie power comes to the wire) switch in your dash, like a rear window defroster or seat heater. turn the switch on then off and it will trick the system into thinking you activated the parking brake.

Hi Dave
No ....go to a hardware store buy a toggle switch than get a single speaker wire (small wire) attach it to the red wire on the back of your pioneer deck (make sure to leave the red wire in back of deck as well) and attach it to the power on the toggle switch do the same with the black wire (ground wire) the black wire will go into the toggle switch under the power wire. finally install the parking break wire from the pioneer unit to the last slot on toggle switch and this should do the trick if not swap the ground spot for the brake spot on toggle switch >>>> MAKE SURE THE TOGGEL SWITCH HAS 3 HOOK UPS to do this correctly (your system will provide sound with the toggle switch off (Blue Screen) but when toggle switch is on you get video while driving) good luck

let me know if you get an answer. i have the same problem

is there an override code I could put in instead of the toggle switch?