Seperate moter from blower blade
SOURCE: Whirlpool Dryer LET7848A - no HIGH heat
have a solid state resistor for each heat setting you have a infinite ohm setting on high this tells the main board that you have an overload and therefore your high setting will not work. it's obvious that you know how to solder on a circuit board so just replace the resistor on the high temp path. your values are in increments of 10 so your high setting should register 50 ohms of resistance. this should solve the problem. please rate the solution........thanks
SOURCE: Looking for the age of Whirlpool electric dryer
Link Below will give you the ability to calculate your manufacture date from the letters in the SERIAL number.
Whirlpool Date Codes
SOURCE: Whirlpool Imperial dryer cyclic thermostate
there is a easyer way to check this put unit back together...put or had on back were vent blows hot exhaust air out...you should feel it get very very hot...then start to cool down..were you could put your had on the vent....if not replaced fixed tsat....please call if need more help..mike..843-384-8474...
171 views
Usually answered in minutes!
×